ALPHARD V2 CB Sidekick with Club Booster User Guide
- October 30, 2023
- ALPHARD
Table of Contents
CB Sidekick
User Guide
CB Sidekick
Bluetooth Connection to Club Booster V2
Power Indicator
RF Connection to Remote Controller
****Power Switch
Charging Inlet(USB C)
Remote Controller
Setting Up The First Time
Step 1 Pair the remote with Club Booster V2
- Switch on remote – press and hold the “power” button for 3 seconds.
- Press both the “stop” and “G” button for 3 seconds until the remote display shows “Remote Pairing”.
- Switch on Club Booster V2, wait 5 seconds. The “RC” sign appears on the remote display indicates the two are paired successfully.
- Switch off both devices.
Step 2: Pair CB Sidekick with Club Booster V2
Switch on Sidekick by pressing and holding the power button for 3 seconds.
Once it is on, press the same button once, the blue LED flashes rapidly.
Switch on your Club Booster V2 and wait for 10 seconds. The blue LED then
turns solid indicates the two are paired.
Setting Up At the Course
Step 1: Place the mounting on the handle If you are a right handed golfer, place the mounting on the left side of the handle. Tighten it by turning the latch and press down on it.
Step 2: Place CB Sidekick onto the mounting Place the CB sidekick onto the mounting and tighten it with the knob. Make sure it is as level to the ground as possible. Rotate it so that the arrow that says “Cart Direction” points forward.
Step 3: Switch on V2, CB Sidekick, and the remote Switch on all 3 devices. Press the “FL” button on the remote. The CB Sidekick starts rotating until it finds the remote’s direction. A slow flashing green LED indicates that it is standing by. Press “M” to choose between following from the left, right, or behind. Press “FL” again and the LED turns flashing red. Walk away and it starts following. Deactivate it by pressing “FL” or “Stop” buttons.
How to Use
The CB Sidekick is designed to be used on fairways. Switch to remote mode on cart path and near the green. It is set to be 6 feet away from the remote. Place the remote inside your pocket or the included belt clip. Holding the remote on your hand makes jerking motion due to your arm swing.
When using the CB Sidekick with your friend who also has one, set one that follows on the left and the other on the right to avoid collision.
Calling-in: you may ask the cart to come to you when you are within the signal range. The range depends on the elevation another factors, but it is typically 30 yards.
Important
- Practice on your backyard before using the CB Sidekick at the golf course.
- Plan your path wisely – avoid getting too close to hazards.
- Charge both the CB Sidekick and the remote controller every time after the round.
- Move the handle bar to the highest position avoids blockage of the signal.
FCC regulatory conformance:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in
a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment. Such
modifications could void the user’s authority to operate the equipment.
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
IC regulatory conformance
This device complies with CAN ICES-3 (B)/NMB-3(B).
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation..
RF Exposure
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment.
UWB devices may not be employed for the operation of toys. Operation onboard
an aircraft, a ship or a satellite is prohibited.
This device is approved under Part 15.519 for handheld use.
antennas mounted on the outside of a building or on a telephone pole, or any
fixed outdoors infrastructure is prohibited.
This device is Hand-held Communication Devices. antennas mounted on the
outside of a building or on a telephone pole, or any fixed outdoors
infrastructure is prohibited.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>