havit HV3005T-BLK-12V Beta Brick Light Instruction Manual
- June 4, 2024
- havit
Table of Contents
havit HV3005T-BLK-12V Beta Brick Light
Product Specifications
Product Specifications
Model No.| HV3005T-BLK-12V| HV3005T-SS316-12V| HV3006T-BLK-12V| HV3006T-
SS316-12V| HV3007T-BLK-12V| HV3007T-SS316-12V| HV3008T-BLK-12V| HV3008T-
SS316-12V
Name| Bata
Material| 316 Stainless Steel Cover + Aluminium Body
Colour| Black| Stainless Steel| Black| Stainless Steel| Black| Stainless
Steel| Black| Stainless Steel
IP Rating| IP54
Input Voltage| 12v DC
Protection Class| (Low Voltage)
Lamp Base| Built in LED
Lamp Wattage| 1x 6w| 1x 3w
Colour Temp| TRI Colour – 3000k, 4000k, 5500k| TRI Colour – 3000k, 4000k,
5500k
Lumens| 480lm, 510lm, 540lm| 240lm, 255lm, 270lm
CRI| > 80
Wiring| Parallel
Dimmable| No
Warranty| 3 Years Replacement*
HV3005 Dimensions| | HV3006 Dimensions| | HV3007 Dimensions| |
HV3008 Dimensions
---|---|---|---|---|---|---
| |
| |
| |
Important Safety Issues
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Modification of this product will void any warranty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- When installing low voltage fittings, Voltage to fitting must be within +or- 5% of voltage required and cannot be installed more than 25m from LED Driver, if not within this allowance warranty will be voided.
- Aluminium and 304SS fittings must not be installed within 5km of any salt water environments.
- All o-rings and seals must be in place correctly to maintain warranty.
- These instructions may be updated at any time due to product improvements, Please visit website for most current installation instructions.
Steps for Installation
- Make sure that the electrical circuit is free of voltage (master switch off )
- Make a hole where fitting is to be placed using dimensions provided on line drawings
- Canister Installation – Insert canister, and ensure that the top is level with wall. Failure to do so will void warranty.
- Gyprock Installation – Attach clips to fitting using screws provided.
- Using an appropriate 12v DC LED Driver – DO NOT CONNECT LIGHT FITTING DIRECTLY TO 240V
- Connect the cable – If more than one fitting installed, wiring must be done in parallel.
- Strip back the cable on both fitting and cable run and twist the positive cables together. Then connect neutral cables together
- Solder all joins using solder and either a heat gun or butane gas torch.
- Cover connections using an adhesive lined heat shrink or gel cap to make connection watertight. Failure to do this will void warranty.
- Heat the heat shrink or crimp the gel cap making sure all connections are covered.
- Remove screws from face, remove face and glass and set aside.
- Remove PCB from fitting by unscrewing the 2 screws found in corner
- Canister Installation – Attach body of fitting to canister making sure body sits just behind canister edge.
- Reattach PCB to fitting by reattaching the 2 screws.
- Colour temperature is preset to 3000k, to change slide switch located on front of PCB to desired colour temperature.
- Reinsert glass and then reattached face making sure screws are tight to avoid any water penetration.
- Gyprock Installation – Insert fitting into hole by pushing down on clips and release once fitting is installed.
- If installed outside apply silicon around edge of fitting to prevent any water from getting inside to electrical connections.
- All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Contact Details
Contact Details:
143 Beauchamp Road| Tel: 02 9381 8300
Matraville NSW 2036| Fax: 02 9666 8881
Australia| Email: sales@havit.com.au
| Web: www.havit.com.au
Warranty Terms & Conditions
Additional Information
Documents / Resources
|
havit HV3005T-BLK-12V Beta Brick
Light
[pdf] Instruction Manual
HV3005T-BLK-12V, Beta Brick Light, Brick Light, Beta Light, HV3005T-BLK-12V,
Light
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>