CALEX HOLLAND 493RT Outdoor LED Smart Lantern User Manual

October 30, 2023
CALEX HOLLAND

HOLLAND 493RT Outdoor LED Smart Lantern

User Manual

CALEX HOLLAND 493RT Outdoor LED Smart Lantern

This manual, A, contains descriptions of all necessary steps for assembling and installing this product. Refer to the icons in the supplementary manual, B, to see which of the following points apply to this product:

CAUTION: Always switch off mains supply before servicing.
Luminaire Installation:

  • Before installing the product check which plugs and screws are best suited for the intended surface
  • Mount the bracket on the wall.
  • Shut OFF the power.
  • Open the easy connector, connect the cable with the connector, make sure the cable wires are correct to connect with L, N.
  • Close the easy connector and tighten it firmly
  • Turn on the power and test the luminaire

This manual, B, contains descriptions of all parameters, specifications and relevant icons in accordance with international standards and safety regulations. However, these do not always apply to the product you purchased. Refer to the icons in the  supplementary manual, A, to see which of the following points apply to this product.
This manual, B, contains descriptions of all parameters, specifications and relevant icons in accordance with international standards and safety regulations. However, these do not always apply to the product you purchased. Refer to the icons in the  supplementary manual, A, to see which of the following points apply to this product.

**** Conformity with all relevant EU Directive requirements

Safety

 If applicable: only use this device for intended purpose; do not use this device if damaged or defective. If this product is damaged, especially if the cable or fitting is damaged, this product must Safety: if applicable: only use this device for intended  purpose; do not use this device if damaged or defective. If this product is damaged, especially if the cable or fitting is damaged, this product must be shut down immediately. In this case, replacement is required; before replacing, turn off power and let device cool  to avoid electrical shock or burn. To disconnect voltage, turn off power.
The adapter (if applicable) must be installed near the device, not connected to any other adapter, and easily accessible. Products may only be used in combination with the original adapter.
This product should only be opened by an authorized technician when maintenance is required. Never carry out repairs yourself.
The adapter (if applicable) must be installed near the device, not connected to any other adapter, and easily accessible. Products may only be used in combination with the original adapter.
This product should only be opened by an authorized technician when maintenance is required. Never carry out repairs yourself.

Removal of your product. This product is made of high quality materials and parts that can be recycled. If you see this symbol on your product, it means that the product is covered by EU Directive 2002/96 / EC.
Ask your own local government about the way in which electrical and electronic products are collected Removal of your product. This product is made of high quality materials and parts that can be recycled. If you see this symbol on your product, it means that  the product is covered by EU Directive 2002/96 / EC.
Ask your own local government about the way in which electrical and electronic products are collected separately in your region. When disposing of old products, observe local legislation and do not dispose separately in your region. When disposing of old  products, observe local legislation and do not dispose of these products in the normal household waste. Properly disposing of old products will prevent adverse ejects on the environment and public health.
Always turn off the power before starting any installation, maintenance, or repair. If applicable, before you start, make sure that there is no voltage on the product when you start the assembly. The best way to do this is to disconnect the power from the mains  until the moment installation, repairs or the assembly is complete. If in doubt, consult a qualified electrician or the store where you purchased the product. Make sure that you always install the product according to the relevant regulations.
According to some regulations, electrical products must only be installed by a qualified electrician.

  1. before installing this product, check which plugs and screws are best suited for the intended surface;

  2. donot connect the product to a power supply while itis still in the package;

  3. donot connect the product to a power supply while it is wound onto a reel;

  4. donot use the product when covered or recessed into a surface;

  5. donot open this product.

  6. Safety Class |: this product must to be connected to an earthed socket; the luminaire is equipped with a ground terminal and must therefore be earthed; connect the ground wire (yellow green vein) to the @-marked terminal.

  7. Safety Class Il: This product is double insulated and does not need to be connected to an earthed socket.

  8. Safety Class Ill: this product is only suitable for very low safety voltage (e.g. 12V)

  9. Intended use: only indoors

  10. The luminaire must not be covered with insulating material.

  11. The luminaire is not suitable for installation in the bathroom, at least notin the indicated area

  12. The luminaire in only suitable for wall mounting

  13. The luminaire is only suitable for ceiling mounting

  14. The luminaire is suitable for wall and ceiling mounting

  15. Strip the wire as indicated in the icon

  16. IP20: This product is intended for use in dry spaces indoors
    IP23: Rain resistant
    IP44 : Splash proof. The product is protected against the intrusion of solid objects greater than 1 mm in size and water spray from any direction.
    IP54: Protected from limited dust ingress, protected from water spray from any direction.
    IP65: The product is dustproof and protected from water jets. The luminaire cannot be used if the housing is broken.

  17. This luminaire is (IP20) for components in the ceiling and (IP21) (IP23) (IP44) (IP65) for components under the ceiling, provided that this luminaire is installed correctly.

  18. Inthe protective glass is damaged, it must be replaced immediately.

  19. Always respect the minimum distance between the light source and the illuminated materials as indicated in the icon

  20. Max….W: Use only lamps of the correct type and never exceed the maximum indicated wattage.

  21. Usea heat-resistant cable to connect the luminaire to the mains

  22. This luminaire is only suitable for lamps with built-in protection or ‘low pressure’ lamps. An extra protective glass is not required.

  23. The luminaire is equipped with a built-in fuse. If the luminaire does not work after replacing the lamp, this fuse must be replaced. If the fixed connection wiring of the installation can be touched, this may only be done by a qualified electrician.

  24. This luminaire is suitable for top-mirror lamps

  25. The luminaire is only suitable for fixed mounting and must therefore not be connected to a power source by means of a connecting cord.

  26. TypeX: If the external flexible cable or cord of this fixture is damaged, it will be replaced bya special cord or cord exclusively available from the manufacturer or its service agent.
    Type Y: If the external flexible cable or cord of this luminaire is damaged, it should only be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
    Type Z: the external flexible cable or cord of this luminaire cannot be replaced; If the cord is damaged, the fixture will be destroyed.

  27. Note that no electrical or other wires in the ceiling or wall are touched during the installation of this luminaire.

  28. Electrical installation wires must never be clamped or twisted (twisted) between the luminaire and the mounting surface.

  29. This product is dimmable and compatible with a TRIAC dimmer.

  30. This product uses LED technology and is only suitable for it.

  31. The light source of this luminaire is not replaceable; when the end of the service life has been reached, the entire luminaire must be replaced.

  32. Replaceable (LED only) light source by a professional

  33. This product must not be covered by objects. Keep this product away from sharp edges, oils and heat.

  34. Nevers this product in an area where there is a risk of explosion or near flammable substances or gases.

  35. If this product is passed on to third parties, manuals must be included.

  36. Keep this product out of the reach of children.

  37. Turn off the product when you leave the room.

Warranty: Any changes and/or modifications to the product will void the warranty. We cannot accept any liability for damage caused by incorrect use of the product.
Disclaimer: Designs and specifications might be subjected to change without notice. All logos, brands and used product references are trademarks or registered trademarks of their respective holders and hereby recognized as such.

https://www.youtube.com/watch?v=KMRjZM9RfhI&list=PL_PPMF5EN2LUlA1VbHtYlzOAWnvim3ZAi&ab_channel=CalexHolland

Please check out our Smart Outdoor playlist on YouTube for more help and inspiration for this product.

Bluetooth Pairing

Enable Bluetooth on your mobile phone for pairing

Getting started

Set up in 4 easy steps

  1. Download the Calex Smart app from the Google Play store, the Apple Store or scan the QR code.
    Before starting the installation, you will need to note the name of your WiFi network and its password, remember to respect spaces and capital letters. Note: this item only works on a 2.4GHz Wifi network, not on a 5GHz WiFi network. Please consult the manual  of your router for settings.

  2. Make sure Bluetooth is enabled on your phone. Open the app. First time user? Follow on-screen instructions to create your account. To add this product start by touching ‘add device’ (+), select the product from the list and follow the on-screen instructions.
    Reset procedure: Switch the product on and off, 3 times

  3. To use Bluetooth Mesh, the Calex Link is required.

For more information, see our website: www.calex.eu

Declaration of Conformity

We, Electro Circle Retail BV, as importer declare that this “radio equipment” is produced in China.
The products passed all tests according to all relevant CE standards and regulations. The complete list of harmonized standards regarding directive 2014/53/EU can be found at:
https://ec.europa.eu/growth/single-market/european-standards/harmonised- standards/reden
The complete Declaration of Conformity can be found at www.calex.eu. For other compliance-related information please contact:

Website: www.calex.eu
email: info@calex.eu
Phone: +31 (0)10-2981980
Postal: Lysistrata 29, 3047 AJ, Rotterdam, the Netherlands

Documents / Resources

| CALEX HOLLAND 493RT Outdoor LED Smart Lantern [pdf] User Manual
493RT Outdoor LED Smart Lantern, 493RT, Outdoor LED Smart Lantern, LED Smart Lantern, Smart Lantern, Lantern
---|---

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals