HUBBLE S-120 120Ah Lithium LifePo4 Battery Instruction Manual

June 10, 2024
hubble

HUBBLE logos-120
MANUAL

It is important that you read this manual before attempting the setup of your battery. Please take note of certain steps to ensure correct inverter compatibility.
Please visit https://www.hubblelithium.co.za for the latest version of this manual.

HUBBLE S-120 120Ah Lithium LifePo4 Battery

WARNING:
Working with high voltage systems is dangerous. Do not attempt to modify your inverter and battery setup unless you are certain you understand the risk.

battery Usage

SINGLE USE:
12.8V is the maximum voltage level for singular use of batteries.

HUBBLE S-120 120Ah Lithium LifePo4 Battery - USE

SERIES:
51.2V is the maximum votlage level for 4 batteries connected in series. Batteries can only be connected in series in groups of 4 at a low voltage state. It is IMPORTANT to empty the power in each group of  batteries before attempting a series connection.

HUBBLE S-120 120Ah Lithium LifePo4 Battery - SERIES

PARALLEL:
In order to connect batteries in parallel all batteries must be the same model, the voltage must be in the same state and the voltage difference must be less than 0.5V to realize parallel connection.
The number of parallel connections is not limited, but more connections will have higher consistency requirements. It is highly recommended that you do not exceed a parallel connection of 4 batteries.

HUBBLE S-120 120Ah Lithium LifePo4 Battery - PARALLEL

SERIES AND PARALLEL:
In order to have a series and parallel connection the batteries must be of the same model, the voltage must be at a low voltage state, each group must be in the same voltage state and the voltage difference must be less than 0.5V.
Up to 4 groups of batteries can be connected in series without limiting the number of parallel connections, however, more parallel connectiong will have a higher consistency requirement. It is recommended  that the number of parallel connections do no exceed 4 groups of batteries.
PAY ATTENTION TO PARALLEL OUTGOING LINES AND DO NOT CONNECT THE OUTGOING LINES FROM ONE BATTERY LUG.

SAFETY PRECAUTIONS

In order to prevent leakage, heating, fire, explosion, performance degradation…etc please use the battery according to the following specifications. Hubble Lithium will not be held liable for incidents involving injury or battery malfunction caused by failure to operate in accordance with the below regulations:

  1. Handle with care and avoid vibrant vibration/movement.
  2. Do not immerse the battery in water or other liquids and PAY ATTENTION TO MOISTURE PROTECTION.
  3. Short circuit between positive and negative terminals of the battery shall be avoided.
  4. Please charge according to the discharge ambient temperature of -10 ˚C ~ 55 ˚C and charge according to the charging current less than the requirements of the specification.
  5. Please discharge according to the discharge ambient temperature of -10 ˚C ~ 55 ˚C and discharge according to the discharge current less than the requirements of the specification.
  6. It is absolutely FORBIDDEN to disassemble the battery, such may cause an internal short circuit and internal material decomposition, fire, explosion…etc. In addition, dismantling the battery may cause  leakage of the battery’s electrolytes which is toxic to the human body. If this elecrolyte leeakage splashes on the skin, eyes or any other part of the human anatomy WASH WITH CLEAN WATER  IMMEDIATELY AND GO STRAIGHT TO THE HOSPITAL FOR TREATMENT.
  7. Do not use fire to dispose of waste batteries, this will cause a dangerous explosion which could result in potentially fatal injuries.
  8. In the case of battery damage, battery deformation, electrolyte leakage, electrolyte smell or any other abnormal behaviours DO NOT USE THE BATTERY AGAIN. Send the battery to the authorized  manufacturer office or relevant institutions for proper treatment. In addition, the battery with electrolyte leakage must be far away from any fire source to avoid explosion.
  9. Hubble Lithium will not be held liable for injuries caused by batteries dismantled without permission.

storage & maintenance

STORAGE
The S-120 batteries must be stored in clean, dry, ventilated rooms at an ambient temperature of 5 ˚C ~ 25 ˚C and keep the relative humidity less than 75%. Avoid contact with corrosive liquids and away from  fire and heat sources. The S-120 maintains approximately 50% ~ 60% power; therefore, it must be charged once every 15 days in storage for about 2-3 hours to prevent over discharge of the battery.

MAINTENANCE

  1. The battery will reach maximum capacity after 3-5 times of us, do not exceed this.

  2. The battery must be used in a ventilated and dry environment away from any flamable objects or fire sources.

  3. The optimum working ambient temperature of the battery is 15 ˚C ~ 35 ˚C, do not exceed or you will risk damaging the normal operation of the battery.

  4. Do not short circuit the positive and negative ends of the battery.

  5. Do not use organic solvent to clean the battery shell. In the case of an accident use carbon dioxide fire extinguishers, carbon tetrachloride extinguishers or sand.

  6. If the battery fails in any way send it to the authorized manufacturer or relevant institutions for proper treatment. For safety precautions DO NOT DISCARD.
    TRANSPORT

  7. The S-120 is suitable for automobile, train, aircraft and other transportation modes. Avoid sunlight and water exposure, and violent vibrational movement.

  8. Insulate the battery with shockproof materials and mark with safety precautions to avoid battery damage during transportation.

  9. The battery must be transported upward and labelled as such. DO NOT place it upside
    down or on it’s side.

  10. Handle battery with care during the loading and unloading process and avoid collisions at all costs.

  11. Do not place heavy objects on top of the battery to avoid damage caused by extrusion.

  12. Labell the battery transportation packaging with moisture, water and fire hazards labels to avoid danger during transportation.

CONGRATULATIONS!

If you have any difficulties with setting up your battery please contact our Technical Support Department via support@hubblelithium.co.za and be sure to include the following information in your initial email  so that we can provide you with timely assistance:

  1. Inverter make & model
  2. Model & number of connected batteries
  3. Are your batteries in Series or Parallel?
  4. A brief description of your system and any issues you may be having
  5. If possible; images of your power system
  6. Contact Details, if we should need to contact you

HUBBLE S-120 120Ah Lithium LifePo4 Battery

SUBSCRIBE TO OUR YOUTUBE CHANNEL TO VIEW OUR VIDEO TUTORIALS: https://www.youtube.com/channel/UCaY_AJhdFtUqoWlWOwscv_Q

Information published on this manual is correct as of the date published on this manual.
Please ensure you have the latest manual which can be obtained from our website at www.hubblelithium.co.za

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals