HCS RC4251608-01R Remote Control User Guide
- June 10, 2024
- HCS
Table of Contents
HCS RC4251608-01R Remote Control
Product Information
The Remote Control RC4251608/01R RC4251608/01BR is a device used to control electronic equipment such as televisions, DVD players, and cable boxes. It operates on radio frequency signals and requires batteries to function. The remote control has various buttons that correspond to specific functions on the electronic equipment it is paired with.
Product Usage Instructions
- Insert batteries into the remote control according to the polarity markings.
- Turn on the electronic equipment you wish to control with the remote.
- Ensure that the remote control is within range of the electronic equipment. The range may vary depending on the specific device.
- Refer to the user manual for your electronic equipment to determine which buttons on the remote control correspond to specific functions.
- Press the appropriate button on the remote control to perform the desired function on the electronic equipment.
- If the remote control is not functioning properly, check the batteries and ensure that the remote is within range of the electronic equipment. If issues persist, refer to the troubleshooting section of the user manual.
- When not in use, store the remote control in a dry and cool place to prolong battery life.
Please note that any changes or modifications to the remote control not expressly approved by the manufacturer may void the user’s authority to operate the equipment and could potentially cause harm or damage to the device.
Know your Remote
How to pair your RCU with a TV
Step 1: input 2*AAA batteries into the Battery compartment.
Step 2: presses the Source key for 3 seconds.
Step 3: After 3s, the blue LED blinks to acknowledge. The LED will blink
when RCU is in pairing mode.
Step 4: When the user releases the key, RF pairing will start, and the
blue LED remains blinking. If pairing is successful, the blue LED will be
turned off after successful pairing.
Note: After RC goes into pairing mode, pressing any key before pairing
successfully will cancel and exit pairing mode except for
Voice Function
Press and release the
Ambilight key
When pressing the
Sleeping Mode
When no activity needs to do, the RC enters sleeping for power-saving
purposes. The sleeping mode behaves as below:
- All LEDs are off.
- IR and RF communications are stopped.
- Any key press will wake up the RC.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Caution
Please take attention that changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
Note
This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>