AI-SONIC S2-C6.2 ACT 2 Way Active Speaker System Owner’s Manual
- June 10, 2024
- AI-SONIC
Table of Contents
**AI-SONIC S2-C6.2 ACT 2 Way Active Speaker System Owner’s Manual
**
Technical features
S2-C6.2
- 6.5″ 2-Way Component Speaker System
- Black sandblasted Stainless Steel Basket
- Black Aluminium Cone Rubber edge
- 1.0 inch ASV Voice Coil
- 12.6 Oz Magnet Structure
- 25mm Silk Dome Neodymium tweeter
- 2-way passive crossover
Technical specification
| MODEL | S2-W6 | S2-T25 |
|---|---|---|
| FS | 64 Hz | 1500 Hz |
| Efficiency (SPL) | 88 dB | 93 dB |
| Qts | 0,85 | n/a |
| Vas | 9,75 L | n/a |
| Impedance | 4 Ohm | 4 Ohm |
| Frequency response | 40 Hz – 4,5 kHz | 3,8 – 25 kHz |
| Power recommendation | 40-150W | 20-100W |
Wiring your system
Tweeter level diagram
Dimensions
S2-C6.2
Tweeter setup
These values are recommendations by our own experience.
When tweeter is mounted towards listener (on axis), tweeter level
adjustment should be -3dB.
When mounted towards center of vehicle (off axis), tweeter level
adjustment should be 0dB.
On dashmount (off axis) installation, tweeter will get window
reflection, and on many cases needs to be connected with *inverted
polarity.**
These setups are just recommendations. Try both ways and choose best for you.
Important Safety instructions
Please read all warnings found in this manual. They inform you of the potential danger of personal injury or damage to property.
Our products are intended for use only by those possessing the necessary specialized knowledge.
The relevant safety regulations regarding related auto parts, the regulations on internal vehicle safety, as well as the regulations of the authorized vehicle manufacturers should be followed diligently.
Hearing damage
Continous, excessive exposure to sound pressure levels in excess of 85dB can
cause a loss of hearing. AI-SONIC components are capable of producing sound
pressure levels greater than 85dB.
Volume and Driver Awareness
Use of sound components can impair your ability to hear necessary traffic
sounds and may constitute a hazard while driving your automobile.
AI-SONIC accepts no liability for hearing loss, bodily injury or property damage as a result of use or misuse this product.
Working on Automobile
Do not use your automobile until all components of the loudspeaker system have
been secured to the interior framework. Failure to do so may turn a component
into a dangerous, flying projectile during a sudden stop or accident
Do not drill or drive screws through any vehicle interior or carpeted floor before inspecting the underside for potential punctures to control lines or cables. Be sure to avoid all fuel lines, brake lines, electrical cable or oil lines when planning the installation.
Before beginning installation of the loudspeaker system remove the minus connector (-) from the automobile battery in order to avoid possible short circuits.
Use care when removing interior trim panels. Car manufacturers use a variety of fastening devices that can be damaged in the disassembly process.
If sheet metal must be cut or removed contact your authorized car dealer for professional advice. By damage to supporting body structures the safety certificate may be withdrawn.
! Shock Hazard !
Do not touch the connectors when the system is running!
Costumer Support
AI-SONIC is a trademark of
Oy Ai-Group Ab
info@audioimport.fi
www.ai-sonic.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>