IKEA RÅKALL Integrated Fridge User Guide
- June 10, 2024
- Ikea
Table of Contents
IKEA RÅKALL Integrated Fridge
Product Information
The product is a refrigerator with a freezer compartment. It comes with accessories such as an egg tray, ice tray, and bottle holders. The refrigerator compartment features a control panel with LED lights that can be used to set the temperature. The appliance has a rating plate on the side of the crisper drawer, and its characteristics, technical data, and images may vary according to the model. The defrosting of the refrigerator compartment is completely automatic.
Product Usage Instructions
- Connect the appliance to the power supply.
- After being switched on, the appliance needs 4-5 hours to reach the correct temperature to store a typical volume of food.
- The ideal food storage temperatures are already factory-set (intermediate).
- Use the control panel with LED lights to set the temperature. Press the C button to adjust the temperature to the desired level.
- The three green LED indicators indicate the refrigerator compartment set temperature.
- Press the C button for 3 seconds to deactivate the appliance. The control panel and lights remain off. Press the button again briefly to reactivate the appliance.
- The ambient temperature, frequency of door opening, and position of the appliance can affect the temperature inside the two compartments. These factors must be taken into account when setting the thermostat.
- To avoid food waste, refer to the recommended setting (Intermediate) and storage times found in the user manual.
- The defrosting of the refrigerator compartment is completely automatic. The formation of water droplets on the rear internal wall of the refrigerator compartment indicates that automatic defrosting is underway. The defrost water automatically runs into a drain outlet and then into a container from where it evaporates.
- Do not place the refrigerator accessories in a dishwasher.
Product Description
- Control panel with LED light
- Glass shelves
- Crisper drawer lid
- Crisper
- Crisper divider
- Rating plate (at the side of crisper drawer)
- Dairy balcony with lid
- Door balcony
- Bottle holder with dividers
- Bottle balcony
- Least cold zone
- Intermediate temperature zone
- Coldest zone
Accessories
First use
Connect the appliance to the power supply. The ideal food storage temperatures are already factory-set (intermediate).
Note:
After being switched on, the appliance needs 4-5 hours in order to reach the
correct temperature to store a typical volume of food.
Important!
This appliance is sold in France. In accordance with regulations valid in
this country it must be provided with a special device (see figure) placed in
the lower compartment of the fridge to indicate the coldest zone of it.
Controls
Refrigerator and freezer operation
- The appliance’s refrigerator compartment features a control panel with LED lights. A different temperature can be set using the C button as shown in the figure.
- The three green LED indicators indicate the refrigerator compartment set temperature.
The following adjustments are possible:
To avoid food waste, please refer to the recommended setting (Intermediate), and storage times found in the user manual.
Stand-by
Press the C button for 3 seconds to deactivate the appliance (the control
panel and lights remain off). Press the button again briefly to reactivate the
appliance.
- Note: This operation does not disconnect the appliance from the power supply.
- Note: the ambient temperature, frequency of door opening and position of the appliance can affect the temperature inside the two compartments.
These factors must be taken into account when setting the thermostat.
To download the full version visit www.ikea.com.
- A Led light
- B Refrigerator compartment temperature
- C Button for temperature regulation and Stand-by function
LED light
LEDs last longer than traditional light bulbs, improve internal visibility and
are environmentally friendly. Contact the Service Centre if replacement is
necessary.
Refrigerator compartment
Defrosting of the refrigerator compartment is completely automatic. The
formation of water droplets on the rear internal wall of the refrigerator
compartment indicates that the automatic defrosting is underway. The defrost
water automatically runs into a drain outlet and then into a container from
where it evaporates.
Caution!
The refrigerator accessories must not be placed in a dishwasher.
Freezer compartment
- This appliance is a refrigerator with a star freezer compartment.
- Packaged frozen food can be stored for the period of time indicated on the packaging.
- Once defrosted, food must be used within 24 hours.
Installation
- The appliance must be handled and installed by two or more persons – risk of injury. Use protective gloves to unpack and install – risk of cuts.
- Installation, including water supply (if any), electrical connections and repairs must be carried out by a qualified technician. Do not repair or replace any part of the appliance unless specifically stated in the user manual. Keep children away from the installation site. After unpacking the appliance, make sure that it has not been damaged during transport. In the event of problems, contact the dealer or your nearest Aftersales Service. Once installed, packaging waste (plastic, styrofoam parts etc.) must be stored out of reach of children – risk of suffocation. The appliance must be disconnected from the power supply before any installation operation – risk of electric shock. During installation, make sure the appliance does not damage the power cable – risk of fire or electric shock. Only activate the appliance when the installation has been completed.
- Be careful not to damage the floors (e.g. parquet) when moving the appliance. Install the appliance on a floor or support strong enough to take its weight and in a place suitable for its size and use. Make sure the appliance is not near a heat source and that the four feet are stable and resting on the floor, adjusting them as required, and check that the appliance is perfectly level using a spirit level. Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient.
- WARNING: When positioning the appliance, ensure the supply cord is not trapped or damaged.
- WARNING: To avoid a hazard due to instability, positioning or fixing of the appliance must be done in accordance with the manufacturer’s instructions. It’s forbidden to place the refrigerator in such way that the metal hose of gas stove, metal gas or water pipes, or electrical wires are in contact with the refrigerator’s back wall (condenser coil).
- To guarantee adequate ventilation, leave a space on both sides and above the appliance. The distance between the rear of the appliance and the wall behind the appliance should be 50 mm, to avoid access to hot surfaces. A reduction of this space will increase the Energy consumption of the product. Please remove the power cord from the condenser hook during installation before connecting the product to the power supply.
When contacting our Service Provider, please state the codes provided on your product’s identification plate. The model information can be retrieved using the QR-Code reported in the energy label. The label also includes the model identifier that can be used to consult the https://eprel.ec.europa.eu database portal.
Inspection checklist
- Please follow the inspection checklist before using your appliance.
- If any answer is NOT please follow the relevant action.
- Please remember to write down the product serial number and article number as required and attach your receipt to this page.
Product serial number (rating plate) *| |
---|---|---
Product artical number (rating plate) | |
Purchasing date| |
| If the answer is YES| Actions to do if NOT**
---|---|---
Consideration Tray
Check that the tube is inside the tray
| No action| Put the tube inside the tray
Making sure gasket seals all around the door when the door is closed| No
action| Refer to the AI – door allignment step
Checking no collision between parts/furniture while opening/closing the
cooling door| No action| Refer to the AI – door allignment step
Secure the installation inside any kitchen system and fixed as required| No
action| Follow the AI for the proper installation
General information
The drawers, baskets, and shelves should be kept in their current position unless otherwise specified in this quick guide. The light system inside the refrigerator compartment uses LED lights, allowing for better lighting than with traditional light bulbs, as well as for very low energy consumption. Doors and lids of the refrigeration appliance should be removed before disposal in the landfill, to avoid children or animals getting trapped inside. This product contains a light source of energy efficiency class G.
Technical Data
| IKEA | RAKALL | 4 | 274 | 35 | F |
|---|---|---|---|---|---|
| Brand | Model | Freezing capacity (kg/24h) | Energy consumption (kwh/year) | Noise | |
| level (dba) | Energy class |
© Inter IKEA Systems B.V. 2022.
To download the full version visit www.ikea.com.