TONE CITY T-M-04 Tape Machine Owner’s Manual
- June 10, 2024
- TONE CITY
Table of Contents
TONE CITY T-M-04 Tape Machine
Product Information
The T-M-04 Delay is a guitar effects pedal produced by Tone City. It allows users to add delay effects to their guitar signal. The pedal has three main controls: LEVEL, TIME, and REPEAT. The LEVEL control adjusts the ratio of dry and delay signal, with clockwise rotation increasing the intensity of the delay signal. The TIME control sets the delay time, which can be adjusted from 20ms to 600ms. The REPEAT control adjusts the repetition of the delay signal, ranging from 1 time to unlimited time. The pedal also has a footswitch for turning it on and off, and a power jack that requires a 9V DC Negative Center power supply.
Product Usage Instructions
- Connect your guitar to the input jack located on the pedal.
- Connect the output jack of the pedal to your amplifier or other effects pedals.
- Ensure that the power supply you are using is a 9V DC Negative Center power supply. Using a power supply with other specifications may cause damage and void your warranty.
- Turn on your amplifier or other effects pedals.
- Press the footswitch on the T-M-04 Delay to turn it on.
- Adjust the LEVEL control to achieve the desired balance between dry and delay signal.
- Adjust the TIME control to set the delay time. The delay time can be adjusted from 20ms to 600ms.
- Adjust the REPEAT control to adjust the repetition of the delay signal. The range is from 1 time to unlimited time.
- Press the footswitch again to turn off the T-M-04 Delay when you are finished using it.
All of the TONE CITY products were Poured into our enthusiasm and focus.We never stop on the path of development
CONTROLS
- LEVEL – Controls the ratio of dry and delay signal . Clockwise is increasing the intensity of delay signal.
- TIME – Setting the delay time.From 20ms to 600ms.
- REPEAT – Control the repetition of the delay signal. From 1 time to unlimited time
SWITCH
- FOOT SWITCH – turn on/off the pedal
JACKS
- INPUT – 1/4″ jack on the input side.
- OUPUT – 1/4″ jack on the output
POWER
This pedal should be operate at 9V DC Negative Center . If the use of other specifications of the power supply cause damage.Your warranty will be voided