BON PERGOLA Manual Screen Shade Set Instructions
- June 11, 2024
- BON PERGOLA
Table of Contents
BON PERGOLA Manual Screen Shade Set
Product Information
Manual Zipper Screen
The Manual Zipper Screen is a retractable screen/shade that can be installed in pergolas, patios, and other outdoor spaces. The screen is designed to protect you from the sun’s harmful UV rays and provide privacy while still allowing fresh air to circulate.
Tools Required
- Motor Regulator (for motorized units only)
- Electrical Adhesive Tape (for motorized units only)
- Wire Clamp (for motorized units only)
Motor Regulator, Electrical Adhesive Tape, Wire Clamp is for motorize unit only
Installation
Step 1:
Before installing the screen/shade, measure the three widths to make sure
they are equal. This is important to ensure proper functioning of the screen.
Step 2:
Clear the work area and lay out all parts to ensure everything is contained
in the box. Before installing, double-check that the sides are level. If they
are not level, it could cause the screen to fail over time. Remove the front
cover.
Step 3:
Lift up the screen and pull down and push upward to double-check if the
screen can retract back to the top without falling down after you push up. If
it slides down after pushing up, you will need to follow the increase tension
instruction on our website Q&A section to increase its tension little by
little until it stays up completely. Failed to check tension could result in
taking the screen down and reinstalling it again.
Step 4:
Pre-drill holes for the screw to connect the side channel and the pergola
post later.
Step 5:
Separate the front rail, plastic zipper guide insert, and back rails.
Insert the back rails into the sides of the box cassette (so they are in one
piece), then screw it onto the pergola with self-tapping screws on each side.
Plan which side you want the screen to align to before screwing the side rail.
Step 6:
Insert the zipper with fabric into the plastic zipper guide insert rails and
align it to the side rail.
Step 7:
Assemble the front rail tight by pushing the front rail into the back rail
(while the plastic zipper guide insert is within).
Step 8:
Pull the fabric down only after the screen is fully assembled for testing.
Following these installation instructions will ensure that your Manual Zipper Screen is properly installed and functions as intended.
Product Installation
Step1 :
Before installing your screen/shade, measure the three width to make sure they
are equal before starting. This is important to make sure the screen will
function properly.
Step 2:
Clear work area and lay all parts to ensure all parts are contained in the box
NOTE: Before installing, double check the sides are level. (not level could cause the screen to fail overtime)
Step 3
Before installing, lift up the screen and pull down and push upward to double-
check if the screen can retract back to the top without falling down after you
push up. If it slide down after push-up, you will need to follow the increase
tension instruction o n our website Q&A section to increase its tension little
by little until it is completely stay up.
NOTE:
Failed to check tension could result in taking the screen down and reinstall
it again.
Step 4 :
Pre Drill holes for the screw to connect the side channel and the pergola post
later.
Step 5:
Separate the front rail, plastic zipper guide insert, and back rails.
Insert the back rails into sides of box cassette (so they are in one piece),
then screw it onto the pergola with self-tapping screws on each side.
Note, plan which side you want the screen to align to before screwing the side rail.
Step 6
Insert the zipper with fabric into the plastic zipper guide insert rails and
align it to the side rail
Step 7 :
Assemble the front rail tight by pushing the front rail into the back rail
(while the plastic zipper guide insert is within).
Step 8 :
Pull the fabric down only after the screen is fully assembled for testing.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>