jmmo M201 Dual Mode Wireless Mouse Instructions
- June 4, 2024
- jmmo
Table of Contents
jmmo M201 Dual Mode Wireless Mouse
Product Specifications
Product name: M201
Working mode: photoelectric induction
Connection: 2.4G, Bluetooth
Working distance: about 10m open distance
Operating vottage: 5V
Product size: 1006235mm
Product weight: 70g±5G
Input: DC 1.5V(AA) battery
Working frequency: 2402-2480MHz
Supported systems: Windows 7, Windows 8, Windows 10, Windows VISTA,
WindowsXP or later versions are recommended
Overview
① Left button
② Right button
③ Mid button
④ DPI Switch button
⑤ Mode switch
Charging light instructions
| When charging | power indicator is red on |
|---|---|
| When the battery is full | the power Indicator is rad off |
| Low power | the power indicator blinks red |
2.4G Mode
- Rip the bottom switch to 2.4g gear.
- Connect the 2.4g receiver to fhe USB interface of the computer device, and it can be used after successful connection.
Bluetooth Mode
- Flip the bottom switch to bluetooth gear.
- Tum on the Bluetooth switch of the computer device, search the mouse name: BT5.2 in the added device, and clfckConnect.
- It can be used after sucressfull connection.
- To use BT5.0 signal, you can long press the MOUSE DPI key, the left mouse key the middle mouse keyandffle right mouse button for four seconds at the same time, the mouse will send BT5.0 signal, re-pairing operation can be done.
Sleep Mode
In wired mode, the mouse does not sleep. In 24g/Bluetooth mode, the mouse will automatically sleep after 10 minutes of no operation. You can wake up the mouse by moving or clicking.
Bluetooth Mode
1 800DPI 2 1200DPI 3 1600DPI
FCC warning
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equioment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital decice, pursuant to part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) the device must accept any interference received, including interference
that may cause undesired operation.
These limits designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined bytumingthe equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealeror an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>