Rubbermaid Commercial 2173520 Motorized Truck and Cart Battery Charger Owner’s Manual

2173520 Motorized Truck and Cart Battery Charger
Owner’s Manual Motorized Truck & Cart Battery
Charger Owner’s Manual
2173520 / 2173896
www.rubbermaidcommercial.com
NWL0001437306

GENERAL SAFETY WARNINGS

WARNING
TO REDUCE RISK OF FIRE OR ELECTRICAL SHOCK,CAREFULLY OBEY THESE INSTRUCTIONS.

• Do not cover the ventilation slots on the top of the charger. Do not set the charger on a soft surface i.e. blanket, pillow. Keep the ventilation slots of the charger clear.

• Confirm the voltage availability at each country location before using the charger.

• If the shape of the plug does not fit the power outlet, use an attachment plug adaptor of the proper configuration for the power outlet.

• DO NOT allow liquid inside the charger.

• DO NOT try to use the charger for any other purpose than what is presented in this manual.

• Unplug the charger and remove the battery pack before cleaning.

• Do not try to connect two chargers together.

• Do not use the charger in the circumstances that the output polarity does not match the load polarity.

• For indoor use only.

• Do not place the battery pack in the sun or in a warm environment. Keep at normal room temperature between 6˚C (43°F) and 40˚C (104°F).

• Do not allow small metal items or material such as steel wool, aluminum foil, or other foreign particles into the charger cavity.

• Do not attempt to recharge non-rechargeable batteries with the charger.

• SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for battery charger Model 2173520 / 2173896.

• Before using battery charger, read all instructions and cautionary markings on battery charger, battery, and product using battery.

• CAUTION – To reduce risk of injury, use only 2173664 or Rubbermaid 60V series approved replacement batteries. Other types of batteries may burst causing personal injury and damage.

• CAUTION – This appliance is not intended for use by children or anyone under the age of 18, and by persons 18+ with reduced physical, sensory or mental capabilities
  or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

• If the cord set is damaged, it must be replaced by a special cord set available form the manufacturer or its service agent.

WARNING
To avoid risk of fire, electrical shock, or electrocution:

• Do not use a damp cloth or detergent on the battery or battery charger.
• Keep battery away from water and water sources.
• Always remove the battery pack before cleaning, inspecting, or performing any maintenance on the tool.

SPECIAL RULES FOR CHARGER

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:

• Appliance shall not emit harmful radiation or present a toxic or similiar hazard due to their operation in normal use.
• This device must accept any interference received, including interference that may cause undesired operation.

CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. The reception can be determined by turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

PROPOSITION 65

WARNING
This product contains a chemical known to the state of California to cause cancer, birth defects or other reproductive harm. Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:

• Lead from lead-based paints;
• Crystalline silica from bricks and cement and other masonry products;
• Arsenic and chromium from chemically treated lumber.

Your risk of exposure to these chemicals varies depending on how often you do this type of work. To reduce your exposure to these chemicals, work in a well- ventilated area, and work with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.

SYMBOLS ON THE MACHINE

You may find the below symbols on the machine. Please study them and learn their definitions. Correct interpretation of these symbols allow you to operate the tool safely.

Symbol	Explanation

Class II
| For indoor use only
| Before charging, read the instructions
| Fuse

RISK LEVELS

The following signal words and meanings are intended to explain the levels of risk associated with this product.

will result in death or serious injury.
| WARNING| Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury.
| CAUTION| Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury.
| CAUTION| (Without Safety Alert Symbol) Indicates a situation that may result in property damage.

OPERATION

6.1 CHARGE PROCEDURE
NOTE
Before use charge the battery pack fully to make sure that the battery pack can get the maximum run time. This battery pack does not have a memory. You can charge it all the time.

1. Connect the plug of charger (2) to an AC power outlet.
2. Put the battery pack (1) into the charger (2).

This is a diagnostic charger. The Charger LED Light (3) illuminates in a specified order to show the current battery status. They are as follows:
CHARGING PROCEDURE (LED INDICATOR)

1. Put the battery pack into the charger.
   • If the status LED blinks RED, remove the battery pack from the charger for 1 minute.

2. Put the battery pack into the charger again.
   • If the status LED blinks GREEN, the battery pack is good.
   • If the status LED stays blinking RED, remove the battery pack and disconnect the charger.

3. Wait for 1 minute and put the battery pack into the charger again.
   • If the status LED blinks GREEN, the battery pack is good.
   • If the status LED stays blinking RED, the battery pack is defective and it is necessary to replace the battery pack.

6.2 EXAMINE THE CHARGER
If the battery pack does not charge correctly:

1. Examine the current of the power outlet with different machines. Make sure that the outlet works.
2. Examine the charger contacts to ensure they are not short-circuited.
3. If the charger is not under usual room temperature, move the charger and battery pack to a location where the temperature is between 6° C to 40° C (42.8° F to 104°F) .

WARNING
If you attempt to charge the battery pack in a warm or hot environment, and the charger LED light is red, remove the battery pack and let the battery cool for approximately 30 minutes.

MAINTENANCE

7.1 CLEAN THE CHARGER
NOTE
Keep the air vent free of blockage, saw dust, and wood dust.
Do not spray, wash, or submerge in water.

• Clear the unwanted material out of the air vent with a vacuum.
• Clean housing and the plastic components with a soft, dry cloth.

IMPORTANT
Do not use strong solvents or detergents on the plastic housing or components.
7.2 STORE THE MACHINE

• Remove the battery pack before you store the charger or disconnect the charger.

TROUBLESHOOTING

pack or charger is defective
or there is a bad connection between the battery pack and charger.| Try to remove and reinsert the battery pack in the charger.
Try charging a different battery pack.
Unplug the charger and wait until the red LED goes out, then reconnect the plug to the power supply.
Charger doesn’t work. Charger shows evaluation mode (LED indicates Red
solid ON).| Battery pack is either too hot, or too cold.| Allow the battery pack to reach
normal temperature. Charging will begin when the battery pack returns to 3°C-47°C (37°F-117°F).

TECHNICAL DATA

Battery Pack

216 WH
Cell number| 15
Battery manufacturer rating = 60V maximum and 54V nominal. Actual voltage varies with load.

Rubbermaid Commercial Products 2-Year Limited Warranty for Motorized

Products and Motorized Product Accessories

Rubbermaid Commercial Products LLC warrants that for a period of two years from the date of purchase by the original end-user purchaser, the items listed below will be free from defects in material and workmanship. Rubbermaid Commercial Products LLC, at its option, will replace, free of charge with postage costs paid for (excluding any costs associated with packaging the defective item back to the manufacturer), the item or any component of the item found to be defective during the warranty period. Keep the original sales receipt, invoice or other proof of purchase. Proof of purchase is required to obtain warranty replacement. This limited warranty is valid only for units which
have been maintained in accordance with the instructions in the owners’ manual supplied with the newly purchased product.

How long does the coverage last?
The limited warranty lasts two years from the date of initial purchase. Proof of purchase is required to obtain warranty replacement.
What will Rubbermaid Commercial Products do?
For a period of two years from the date of purchase, if an item in the table set forth above proves defective in material and workmanship during normal use by the purchaser of this product, Rubbermaid Commercial Products will replace the item or any component of the item found to be defective during the warranty period with a new or remanufactured replacement part at no cost to the purchaser. If the item is no longer available, then replacement will be made with a similar item of equal or greater value. This is your exclusive warranty.
What does this warranty not cover?
The warranty applies only to the original end-user purchaser/owner from the date of initial purchase and is not transferrable (excepted where prohibited by local law, which  may include the Province of Quebec). Do NOT attempt to repair or modify the items to remedy any damage or defect covered by this limited warranty. Rubbermaid  Commercial Products LLC reserves all rights to decline coverage if the defect or damage was caused by unauthorized attempts to repair or modify the item. All failures or defects must be reported within the warranty period. Any use of the product for purposes other than its intended use will void this limited warranty. Damage caused as a  result of use above capacity limits of the product are not covered by this limited warranty. This limited warranty does not cover normal wear or damage resulting negligent use or misuse, disassembly, repair, or modification, or from storing the unit outside of recommended shady, cool and dry environments. Rubbermaid Commercial Products LLC expressly excludes from this limited warranty and denies liability for defects or damage caused by repair or modification.
How do you get warranty support?
RCP will issue a replacement of the item or any component of the item found to be defective when the consumer provides a proof of purchase (either a bill of sale, receipted invoice, or other proof that the product is within the warranty period), along with a full description of the defect, to www.rubbermaidcommercial.com/contact-us/ or Toll Free 800-347-9800 Monday – Friday, 8:00 a.m. – 5:00 p.m. Eastern. RCP reserves the right to request photographic proof of product defect, and request that the defective product in question be shipped to RCP (postage provided by RCP) to inspect the product or to aid in quality control efforts.
THIS LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTY, WRITTEN OR ORAL, INCLUDING BUT NOT LIMITED TO ANY EXPRESS WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS EXPRESSLY LIMITED TO THIS LIMITED WARRANTY PERIOD.
THE PURCHASER’S EXCLUSIVE REMEDY FOR BREACH OF THIS LIMITED WARRANTY OR OF ANY IMPLIED WARRANTY OR OF ANY OTHER  OBLIGATION ARISING BY OPERATION OF LAW OR OTHERWISE SHALL BE LIMITED AS SPECIFIED HEREIN TO REPLACEMENT OF THE PRODUCT. IN ANY EVENT, RESPONSIBILITY FOR SPECIAL, INCIDENTAL AND CONSEQUENTIAL DAMAGES IS EXPRESSLY EXCLUDED.
RUBBERMAID COMMERCIAL PRODUCTS SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES WHATSOEVER.
Legal rights vary from state to state, and some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages; therefore, the above limitations or exclusions may not apply to you if precluded by local law.
This limited warranty gives you specific legal rights, and you may have other rights that vary from state to state or province. If you believe your product carries a warranty not described above, call our Consumer Care Department at 800-347-9800 for additional information or contact us at www.rubbermaidcommercial.com/contactus

HELPLINE:
Warranty support is available by calling our toll-free helpline, at 1-800-347-9800.
USA and Canada
Rubbermaid Commercial Products LLC
4110 Premier Drive
High Point, NC 27265
www.rubbermaidcommercial.com
©2022 Rubbermaid Commercial Products,
Product of: Rubbermaid Commercial Products, LLC
8900 Northpointe Executive Park Drive,
Huntersville, NC 28078
www.rubbermaidcommercial.com
Contact us: 1-888-347-9800

References

• Rubbermaid Commercial Products | Official Website
• Rubbermaid Commercial Products | Official Website
• Contact RCP Customer Service

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>