AILORIA DEPLAQUED Sonic Tooth Cleaner Instruction Manual
- June 4, 2024
- AILORIA
Table of Contents
AILORIA DEPLAQUED Sonic Tooth Cleaner
PRODUCT FEATURES
The AILORIA DEPLAQUED sonic scaler is ideal for cleaning teeth at home. It removes tartar, plaque and discoloration, even from hard-to-reach areas.
- Intelligent high-frequency vibration
- Ergonomic design for comfortable handling
- 5 intensity levels
- Cordless battery operation
- Charging time approx. 2 hours
- Battery life approx. 6-8 hours when fully charged
- Charging of the lithium-ion battery via USB
- Rated voltage: 3.7V
- Rated current : 200mA
- Battery capacity: 300mAh
- Charging voltage: 5V
Overview
SAFETY INSTRUCTIONS
- Always keep the USB cable and USB adapter away from water and other liquids.
- Remove the USB charging cable before cleaning the ultrasonic scaler.
- Do not use the product if it is damaged. The sonic scaler can only be repaired by the manufacturer.
- Children and persons with reduced physical or mental capabilities or lack of experience and knowledge should only use the product under adult supervision and instruction.
- Always keep DEPLAQUED out of the reach of children.
- DEPLAQUED is only suitable for cleaning teeth and should not be used for any other purpose.
- If excessive bleeding of the gums or pain occurs and persists while using the sonic scaler, please consult your dentist.
- The product should not affect pacemakers in any way. However, as a maximum precaution, we recommend that you consult your doctor before use.
- If you have undergone jaw or gum surgery in the last two months or if you have any health problems, consult your doctor before using DEPLAQUED.
- Clean the DEPLAQUED metal attachment with water after each use and wipe the housing with a damp cloth. Sterilize the tooth cleaner with alcohol if necessary.
- The sonic scaler is protected against water splashing according to IPX6 protection standard. However, do not keep the product under water for a long period of time.
- The product contains a rechargeable battery. Keep the sonic scaler away from fire and high temperature to avoid danger.
COMMISSIONING
Charge the sonic scaler before the first use. Charging time is approximately 2 hours to charge the sonic scaler before first use or fully discharged battery.
CHARGING PROCEDURE
The connector for the charging cable is located
at the bottom of the back of the unit. Open the silicone cap and connect the
charging cable to the sonic scaler. Connect the other end to a power source
(wall socket) using the USB charging adapter provided. Alternatively, you can
also connect the USB cable to a USB interface (e.g. PC or notebook).
The sonic scaler cannot be used during the charging process. A red light
shines in the transparent base for the duration of the charging process. When
the charging process is completed, this is indicated by a green light.
APPLICATION
Press the ON/OFF button to switch on the sonic scaler. Select the desired
intensity using the arrow keys.
The following 5 intensity levels are available:
Intensity level 1: 8321 vibrations per minute
Intensity level 2: 9787 vibrations per minute
Intensity level 3: 11195 vibrations per minute
Intensity level 4: 12423 vibrations per minute
Intensity level 5: 13320 vibrations per minute
Start cleaning the teeth by gently placing the metal attachment on the areas
with plaque and discolouration. Now slowly move the metal tip over the areas
to be cleaned. This process can be repeated several times until the desired
result is achieved. The sonic scaler can also be used on the edges of the
teeth and in the spaces between the teeth. Move the sonic scaler carefully to
prevent possible injuries to the gums.
Clean the metal head with water after each use and wipe the housing with a
damp cloth. Sterilize the sonic scaler with alcohol if necessary.
DISPOSAL
The product must not be disposed of with normal household waste. Follow local
regulations for separate disposal of electrical and electronic products.
Proper disposal will help prevent negative effects on the environment.
MANUFACTURER
VEHNS GROUP GmbH
Theatinerstrasse 40-42
80333 Munich, Germany
[email protected]
www.vehnsgroup.com
www.ailoria.de
MADE IN CHINA
Subject to alterations and errors
The manufacturer accepts no liability for damage caused by incorrect, improper
or incompatible use of the product.
© VEHNS GROUP GmbH
VEHNS GROUP GmbH, Theatinerstrasse 40-42 80333 Munich, Germany