Inrico T310R PoC Radio Instructions

T310R

T310R PoC Radio

Unpacking and Device Checking

Please upack and take out the device and all accessories carefully, and ensure all lists have been gotten before discarding the cardboard box. If any items are lost or damaged in transit, please contact with our distributors.

Accessories

Handling Precautions

Please read the following notice carefully. It is very important for device users to gain general knowledge and risks.

● Do not overcharge the battery
Please stop charging if it can’t be fully charged within required time. The battery probably overheats, smokes, bursts or suddenly be on fire due to abnormal charging process.  When fully charged or not charged, please disconnect the charger and unplug it from the power outlet.

● Do not discard battery in a microwave or high pressure container.
The battery probably overheats, smokes, bursts or suddenly be on fire.

● Do not expose damaged battery near any fire.
If the battery is broken, leaking or has an abnormal odor, please remove it from flammable areas immediately. The fluid in the battery is flammable, which may cause smoke and fire.

● Do not use abnormal battery
If the battery is with odd smelly, discolored, deformed, etc., please stop charging or disassemble from the device immediately.

● Please use authorized power adaptor
To comply with warranty terms and avoid damages, charge the battery using a specified charger for best performance.

Battery Care

Fully Charge Battery Before Initial Use
● Do preserve battery life by switching off a device and removing the batteries when it’s not being used, and is not expected to be used for extended periods of time.
● Do practice proper battery storage by keeping batteries in a cool, dry place at normal room temperature.

Properly Store Batteries
● Remove the battery from the device.
● Charge and discharge the battery to 40%-65% if it will not be used for 10 days or more. This can greatly extend the battery life.
● The battery should drop below 65% when it is idle for more than 10 days to prevent it from swelling.
● Store the battery in cool and dry environment that’s less than 25℃

Features of Lithium Battery
● Battery capacity will reduce after multiple charging cycles.
● The battery capacity drops gradually even without being used.
● Longer charging time is required in shady place.
● Charging and storing Lithium battery in warm condition will short its lifespan. Please do not leave them inside the vehicle or near the heater.
● If the battery working time has reduced significantly, please replace the battery immediately in avoidance of fluid leakage.

Clean and Maintenance

● Before cleaning and maintaining the device: please stop running, turn off the device, and disconnect all connections with other equipment.
● When you do not use the radio, please cover the accessories connector.
● When cleaning the dust, please use soft brush and neutral detergent (no strong corrosive chemicals) to wipe it.
● Please keep the equipment and accessories dry. Please do not use the microwave oven or hair dryer or other heating devices to dry them.

Product Overview

Function Sheet

Release the PTT button to listen.
2| volume +| Press to increase the volume
3| volume –| Press to decrease the volume
4| Select button| Select an option
5| Home| Enter the main interface
6| Return button| Back to previous menu
7| SOS/Programmable Key F2| Default long press for SoS, Customizable keys in the management platform
8| Dial button| Make a voice call , Long press to turn off the phone, short press for screen off
9| Hang-up button| Hang up during a call
10| Programmable Key F3| Default short press to play back voice ammable, Customizable keys in the management platform
11| Navigation button| Press OK to confirm,  Navigation key can turn up, turn down, turn left, turn right
12| | Return button + key to unlock
13| 0| Long press to turn on/off flashlight
14| #| Long press to switch mute/vibration mode
15| Camera(optional)| Photo shoot
16| NFC (optional)| NFC function must be in the patrol mode to take effect

Accessories Installation

1. Insert SIM card

2. Insert Micro SD card

3.Attaching the Battery Cover
● Push the battery cover until it clicks into place.
● Push the battery cover down.

4.Close the Battery Cover
( a ) Push up into the battery cover socket
( b ) Lock the battery batchOpen the battery cover : Flip down the batterybutton and open the battery cover

5.Attaching the Belt Clip
( a ) Align the top of the clip with the slot ;
( b ) The end of the clip is stuck on both sides otthe end of the walkie- talkie:Uninstall the belt clip : Remove from the bottom , andthen the top.

6.Charging batteries
Plug one end of the USB cable into the battery charging port, and the other end into the adapter. After the adapter is powered on, the battery charging indicator lights up red,  and when fully charged, the red light turns green.

Basic Functions

1.Power on/Power off
● Power On: Long press the power button for 4 seconds and the program will start.
● ower Off: Long press the power button for 4 seconds.
2.Screen unlock
Short press the power button to lock the screen.
Press the back button with * to unlock.
3.Initiate a Call
● Press PTT button and start to talk.
● The LED light is blinking green after loading the APP.
● The LED light is solid red during transmitting.
● The LED light is solid green during receiving.
● If occupied when other person is talking, the PTT button is invalid.
4.Voice Playbacke
● Short press the F2 button to playback cyclically the latest 10 voice records.
● Press the PTT button, return automatically to the last voice record.

Status Indicators

Specification

WCDMA: B1/B2/B5/B8
TDD: B38/B39/B40/B41
FDD: B1/B3/B5/B7/B8/B20/B28A/B28B
US
version| GSM:  B2/B5
WCDMA:  B2/B5
TDD: B40
FDD: B2/B4/B5/B7/B66
Support| GPS/BDS  RFID
CPU| T107
Memory| 48MB(RAM)+ 128Gb(ROM)
Camera| 0.3MP （optional ）
Voltage| 3.8V
Screen Size| 2.4inches,240×320 Pixel
Battery| 3400 mAh
Dimension (HWD)| 1366021.5 (Without Antenna & Belt clip)
Weight| ≈180g
Working Temperature| -10°C ~ 55°C
Storage Temperature| -20°C ~ 55°C

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this  device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off  and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Guidelines:

● Do not remove the RF Exposure Label from the device.
● User awareness instructions should accompany device when transferred to other users.
● Do not use this device if the operational requirements described herein are not met.
Operating Instructions:
● Transmit no more than the rated duty factor of 50% of the time.
To transmit (talk), push the Push-To-Talk (PTT) button.
To receive calls, release the PTT button.
Transmitting 50 % of the time, or less, is important because this radio generates measurable RF energy exposure only when transmitting(in terms of measuring for standards compliance).
● Hold the radio in a vertical position in front of face with the microphone(and the other parts of the radio, including the antenna) at least one inch (2.5 cm)away from the nose.
Keeping the radio at the proper distance is important because Antenna should be kept away from eyes.

—Consult the dealer or an experienced radio/TV technician for help.

SAR tests are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands,  although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. Before a new  model device is a available for sale to the public, it must be tested and certified to the FCC that it does not exceed the exposure limit established by the FCC, Tests for each  device are performed in positions and locations (worn on the body)as required by the FCC.

For face-up,10mm was used for test, this equipment should be installed and operated with minimum distance 10mm. For body worn operation, this model phone has been  tested and meets the FCC RF exposure guidelines when used with an accessory designated for this product or when used with an accessory that Contains no metal and that  positions the handset minimum of 5mm from the body.
Non-compliance with the above restrictions may result in violation of RF exposure guidelines.
RF Exposure Compliance and Control Guidelines and Operating Instructions
To control your exposure and ensure compliance with the general/uncontrolled environment exposure limits always adhere following procedures.

● Do not remove the RF Exposure Label from the device. RF exposures decrease with distance from the antenna.
● When worn on the body, always place the radio in approved clip, holder, holster, case, case, or body harness for this product. Use of non-approved accessories may result in  exposure levels,which exceed the general / uncontrolled environment RF exposure limits.
● Use only manufacturer’s name approved supplied or replacement antennas,batteries, and accessories. Use of non-manufacturer-name approved antennas, batteries, and may  exceed the FCC RF exposure guidelines.
● For a list approved accessories please consult your local dealer for information.
Max. SAR Level(s) Reported(W/kg)
Body :0.66W/kg, Face Up:0.99W/kg
Limit (W/kg):1.6W/kg

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>