iONLED IMD-200W LED Dimmer Set Instruction Manual
- June 10, 2024
- iONLED
Table of Contents
IMD-200W LED Dimmer Set
Instruction Manual
Specifications:
EAN-code: 8718836970214 (master)
EAN-code: 8718836970153 (Slave)
EAN-Code: 8718836970078 (SET)
Model: IMD-200W-Master
Model: IMD-200W-Slave
Model: IMD-200W-Set (1x master 1x slave)
Voltage: 200-240VAC (50Hz)
Min/Max belasting: 200VA
Afmetingen frameplaat: 70,9 x 70,9 x 22mm
Inbouwmaat: 50 mm x 50 mm x 23 mm
Type/Sort dimmer: LED dimmer
This product complies with European safety regulations IEC60669-2-1 and EMC
standards EN55015, EN61547,EN61000-3-2, EN61000-3-3
We recommend that dimmers are always installed by a qualified electrician.
To prevent overheating and possible damage to the dimmer or other equipment,
do not connect the dimmer to a wall socket. If the wall socket is connected to
the Dimmer,
ensure that only LED lamps, low-voltage electronic fixtures, fluorescent
fixtures are used and that they do not exceed the wattage permitted by the
Dimmer.
Step 1:
Turn off the power in the fusebox that supplies the dimmer or switch.
Step 2:
Install the dimmer according to the following example (see figures 1, 2 and
3). It is possible to connect five Slave dimmers to one Master dimmer.
Connect your switch wire to this terminal ( ).
Connect your power wire (L) to the socket next to this power sign
To use the dimmer as a two-way switch, connect the switch wire of the switch
(L).
Step 3:
Adjusting your dimmer to your desired settings.
Resetting the Dimmer
Press the dial knob button more than 8 seconds to reset the dimmer to the
factory default settings.
Minimum Brightness Adjustment
- Turn Dimmer ON.
- Turn rotary knob 360° anti-clockwise three times. (three full turns), or continue turning counterclockwise for five seconds.
- The lamp(s) will blink once.
- Press the dial once within 5 seconds.
- The lamp(s) will flash once and you are now in the minimum brightness adjustment mode.
- Turn the rotary knob clockwise to set the minimum brightness. Turning counter-clockwise reduces the brightness (minimum adjustment range between 0 – 50% of full brightness). Then adjust the minimum brightness to the desired level.
- Press the rotary knob once to save the minimum adjustment setting and to exit the minimum adjustment mode.
- You are now back in the normal operating mode and the installation is complete.
Maximum Brightness Adjustment
Similar to the Minimum adjustment above, except step 2 – Turn dial Knob clockwise instead of turning Anti-clockwise.
ION INDUSTRIES
In der Au 6
55452 Windesheim
Germany
www.ionindustries.com
info@ionindustries.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>