SECRT X12 Home Security Camera User Guide

X12 Home Security Camera

Product Information

The product is a surveillance camera with the following features:

• Brand: Bluelighton
• Network Connectivity: 4G
• Resolution: 4MP
• Focal Length : 2.8mm
• Storage Capacity: up to 128G
• Pan Angle: 355 degrees
• Power Supply: Two 21700 batteries (not included)

Product Usage Instructions

Resetting and Pairing the Network

To reset and pair the network, follow the steps below:

1. Press the Reset button.
2. Wait for the Bluelighton light to turn on, indicating successful pairing with the 4G network.
3. If the Red light turns on instead, it means that the device failed to connect to the 4G network.

Troubleshooting Push Notification Issues

If the device is online and there is a trigger event, but the mobile phone cannot receive the push message, follow the steps below:

1. Make sure that the app on the mobile phone has turned on self-starting function and has enabled the notification function on application permission.
2. Turn off battery optimization and turn off the function of end app when phones in standby. Note that mobile phone manufacturers may have different optimization methods, so please take the actual situation as the standard.

Power Supply

The device can work with two 21700 batteries alone. These batteries are not included in the package and need to be purchased separately.

Statements

FCC Warning Statement

To prevent harmful interference, connect the equipment into an outlet on a circuit different from that to which the receiver is connected. If you need help, consult the dealer or an experienced radio/TV technician. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Statement

To maintain compliance with FCC’s RF Exposure guidelines, this equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter.

Package List

Please check and make sure the camera (hereinafter referred to as “The Equipment”) is in good condition and all below parts are included after opened the package.

Appearance Introduction

Installation Guide

Please take out the bracket from the eqllipment a5 shown in the figure

1. Install the base on the wall using the mounting screw in the accessory package
2. Align the mounting bracket holes of the machine with the base screws for installation
3. Toggle the power ON I OFF to turn the camera on or off
4. TYPE-C interface, Solar power input port
5. Press the reset button for 5 seconds. waiting for the indicator light turn to red slow flash (The equipment should be in ‘Norking condition, long press, sleep state is invalid)
6. TF card slot, install TF card for video storage

Equipment Connection

Thanks for choosing our product. Please scan the following QR codes to install the app on your mobile Then set up your Equipment by following steps atter It’s done,

1. Download and install the Mobile APP Scan the fo/101Ning QR codes or seach for ·usox· from the App Store(for iOS devices) or Google Play Store (for Android smartphones) to dO’tmload and install the app.

2. APP REGISTRATION
   Open the app then input your E-mail address then press ‘Register’. Check and select to agree the agreement then your E-mail box will get an verification code. ( For better user’s experience, please allow to open all permissions to avoid mtssmg any no~ficaMns from tile app,) Set the login password and confrim the login passvrord. Then press ‘Register’ to next step. (For your password safety, the password requires more than 8 characters plus combination of letters) We send a verify mail to you. go to your mail box click the lmk to complete the verificationEnter your E-mail address, and password, d ick logm . (APP will auto fill the account 1nfomaion)

3. CONNECTION
   Press ‘Add Family’ then set the room or position as per reminders.Input the necessary informalton just like Country, Province, then press ‘Done’.Insert the SIM card into devtce tnen put the battery into tile decice, and some of models need install antenna.

Enter your family name and then press ‘Next’

Press ‘Add a device’ to add a smart device

After the power on the device. ‘.vait torabout 1 mtnute the device bule LED light up ,Then press next

If the device blue LED not light up. please check. below config noles.
Find the UID QR code on deive , then use APP scan the QR code,

APP are search the device in intemetit may take 5-60 seconds

Please read it carefully before using the product

The device 1,vill enter to the device list automatically. Setup success! The device 1s ready to use

4. USING THE APPClick the “Ca~ndar” icon on the right top comer , then choose the date ta playback the vicoes from cloud storageChoose the desired date to check all videos from the cloud.

SPECIAL NOTES!

Select the name and device location then press ‘Done.’

Technical Specification

Function Introduction

3 built-in 21700 battery cells with 14400 mAh
Million HD Pixels with Ultra-thin 2.8MM Wide-Angle Lenses
Support w aking up device by mobile phone within 1 second.
4G connection
High quality two-\vay talk with noise cancellation
Support PIR human body infrared detection, It will push alarm information to your mobile phone APP immediately when someone is at the door
Day and night mode can be switched automatically. The image is clear ly and visible for your safety and family security no matter its day or night

Q &A

Q: The device is online and there is a trigger event. but the mobile phone cannot receive the push message?
A : The app on the mobile has turned on ‘self-starting” function and has enabled the notification function on applicat ion permission. Turn off “battery optimization” and turn off the function of end app when phones in standby (The mobile phone manufacturer’s optimization method is inconsistent Please take the actual situation as the standard,)

Q: What power supply mode does the device support?
A: The device can work with two 217DD battery alone

Tip : There will be no flKther notific.ation of any change: of lhe: above functioruc Please take the actual objec1 as the standard.Thanks’

FCC Warning Statement

Changes o r modif ications not exp ress ly approved by the party responsib le for compliance could void the user’ s authority to o perate the equ ipment, Th i s equipment h as been tested and found to comply with the l imits for a Class B d ig ital dev ice, pursuant to Part 15 of the FCC Ru les, These lim i t s are designed t o p rovide reasonable protection against ha r mfu l interference in a residential installation, This equipment generates uses and can radiate radio frequency energy and, if not i nstalled and used in accordance wit h the instructions, may cause harmful i nterference to rad io communications, However, there is no guarantee that interference w ill not o ccur in a particular installation, If this equipment does cause harmful interference to radio or television recept ion.which can be det ermined by t urning t he equ ipment off and on, the user is encouraged to try to correct the int erference by one or more of the follo wing measures:

• Reorient o r relocate 1he receiving antenna,
• Increase 1he separation between the equipment and receiver,
• Con nect the equipment into an ou t let on a circuit different from that to which the receiver is connected,
• Consu lt the dealer or an experienced radio/TV 1echnician for help,
• This device complies w it h part 15 of t he FCC Rules,

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, i ncl udi ng i nterfe rence tha t may ca use undesi red o perat ion,

RF Exposure Statement

To mai n t ain compl iance w ith FCC’s RF Exposure g uidelines, This equipment should be instal led and operated with minimum d istance of 20cm the radiator your body, This device and its antenna(s) must no t be co- located o r o peration in conjunction with any o therantenna or t ransmitter,

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>