HALCYON EX115 Dimmable LED Wall Light Instruction Manual
- June 10, 2024
- HALCYON
Table of Contents
EX115 Dimmable LED Wall Light
Instruction Manual
Product parameter
| Model No. | Current | Power | LED | Colour | Size(DXH):mm | Material | IP Grade |
|---|---|---|---|---|---|---|---|
| EX115 2BB | 220-240V-50/60Hz | 2x4W | Epistar | 2700K | Ø 100*156 | SS316 | IP65 |
| EX115 2BCO | 220-240V-50/60Hz | 2x4W | Epistar | 2700K | Ø 100*156 | Copper |
IP65
EX115 2BSS| 220-240V-50/60Hz| 2x4W| Epistar| 2700K| Ø 100*156| SS316|
IP65
Symbols
|
---|---
| Class I luminaire, requires earth. Not Double insulated.
| LED light source.
| The WEEE symbol, indicating separate collection for WEEE-Waste of electrical
and electronic equipment, consists of the cross-out wheeled bin.
| All the material used is up to standard.
| Working current.
SAFETY INSTRUCTIONS
Read these instructions carefully before commencing installation and retain for future reference. The luminaire should be installed by a licensed electrician and in accordance with local regulations. Make sure that the power is off before installation or maintenance. Install as described.
Installation Instructions
Take pride with installation. Supplied adhesive 3M seal must be used between
installation surface and base plate. Cable entry glands and screwheads must be
covered in silicone sealant. Failure to do so may cause luminaire failure from
water ingress.
– Modification or misuse of the luminaire voids warranty.
– Do not connect luminaire to live power source.
– Take care during installation, incorrect connection may damage the luminaire
resulting in reduced lifespan.
– Halcyon lighting is free to change the design, specifications and
instructions for assembly of the luminaire without notice.
– Halcyon Exterior products go through extensive waterproof testing prior to
sale. Due to the nature of the tests all Copper luminaires will have slight
“water staining”. Please note that once installed Copper develops a natural
patina finish and this will negate any effects from the aforementioned testing
process.
All exterior luminaires (with the exception of copper) require periodic
cleaning to protect the surface and/or coating from corrosion and ensure tidy
appearance for the lifespan of the product. Wash with care using a soft brush
and warm soapy water using a neutral detergent. Coastal areas require extra
attention, especially fittings which are under eaves/soffits and do not have
any exposure to rain. Do not use a water blaster or high pressure hose, do not
submerge fillings for extended periods of time. 316 stainless steel fittings
will still develop surface rust or “tea staining” if left uncared for.