Lindab FTMU4 UltraLink Monitor Instruction Manual
- June 4, 2024
- Lindab
Table of Contents
Lindab FTMU4 UltraLink Monitor Instruction Manual
Mounting instruction
Positioning
- ±5 % or l/s (Ø100 = ±1,00, Ø125 = ±1,25, Ø160 = ±1,60, Ø200 = ±2,00, Ø250 = ±2,50, Ø315 = ±3,15, Ø400 = ±4,00, Ø500 = ±5,00, Ø630 = ±6,30)
Declaration of conformity and FCC statement
FCC cuation and statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications not expressly approved by the part responsible for compliance
could void the user’s authority to operate the equipment. This equipment
complies with FCC exposure limits set forth for an uncontrolled environment.
“This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.”
This declaration of conformity is established under the sole responsibility of the manufacturer identified in point 5.
Signed for and on behalf of the manufacturers by:
Authorised person:
Karel Kleinmond
Group Operations Director
2021-01-18 Karlovarska, Czech Repulic
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>