Dawlance WD-1051 NOIR RED Water Dispenser User Manual

Dawlance WD-1051 NOIR RED Water Dispenser

SAFETY INSTRUCTION

1. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
2. Children should be supervised to ensure that they do not play with the appliance.
3. This appliance is intended to be used in household and similar applications such as:
   • staff kitchen areas in shops, offices and other working environments; farm houses and by clients in hotels, motels and other residential type environments; bed and breakfast type environments; catering and similar non-retail applications.
4. The appliance must not be cleaned by a water jet.
5. The appliance is suitable for indoor use only.
6. WARNING: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
7. WARNING: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
8. The appliance must not be immersed.

FUNCTION INTRODUCTION

1. This series model can satisfy the need of tea & coffee and making drinks .. It must be used indoor only.
2. With adoption of distinctive thermal isolation technology, this machine can minimize thermal exchange between hot & cold water.
3. WARNING: Do not damage the refrigerant circuit.
4. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.

PARTS NAMES

NOTE:
This machine is suitable for bottle of 3 or 5 gallons. Don’t use unhealthy hard water. This machine should work under environment of temperature from10°C-43°C, relative humidity not higher than 90%

OPERATION INSTRUCTION

1. Tear the label from the bottle.
2. Vertically insert the bottle into the bottle supporter on top of the Don’t plug the power cord or push the heating switch until water runs out from the tap of hot water.
3. Insert the plug to socket, then tum on the Indicators light up accordingly once the machine works.
4. Vertically pull out the bottle by two hands when the bottle is empty, then replace it with another bottle of
5. This appliance should work under environment of temperature from  10 °C~43c.
6. This appliance is not suitable for installation in an area where a water jet could be used

CAUTION

1. Keep this machine in a dry place and avoid direct Rear of the machine should be no more than 75mm from the wall. Never put the machine on paper or foam, which may cause unstable condition. Never put anything flammable beside this machine.
2. To avoid damage to the machine, don’t plug the power cord or push the red switch until water runs out from the tap of hot
3. In case hot water is not needed for a long time, turn off the switch accordingly to sav
4. In case not to use this machine for a long time, turn off the switch, then pull the plug out from socket and drain the remaining water through draining
5. No,ern,e “””” J;qwd to domnho macbm<. Sbidly proltibit using water to splash it.
6. Never turn the machine on/off by plugging in/out from the socket. Also never increase the length of the power supply cord to avoid fire.
7. Ifthe supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
8. Never turn the machine upside-down or lean it more than 45°.
9.  When the machine is under the ice point and blocked by ice, the cooling switch must be closed for 4 hours before turning it on again to continue its operation.
10. This machine should not be turned on until 3 minutes later after turning off the power switch.
11. When first time to utilize the refrigerating function, let the refrigerating function be operated for at least 2 hours before putting anything into the cabinet. No wet or hot goods is allowed to be put into the cooling cabinet. Leave suitable space between the goods to ensure the interior airflow.

TROUBLESHOOTING

No hot or cold water

| I .Over consumption of hot or

cold water in s hort time

2. No power suppl y

| 1. Just wait a moment , then hot/cold

water i s available again.

2. Connect plug to socket, turn on heating and cooling switch.

No water running out from taps| I. Empty bottle

2. Inlet of bottle support er blocked by bottle seal

| 1. Replace it with another one.

2. Clean out wasted paper & bottle seal, install bottle again.

Leakage from bottle supporter| Broken bottle| Replace it with a new bottle.
Noisy operation| Not placid installat ion| Place the machine on placid & solid

surface.

CLEANING

To avoid accident, cut off the power supply before operation according to the following instructions:

1. The machine had been disinfected before departed from factory. Clean the dispenser prior to installing a full bottle of water for the first time
2. Before cleaning, make sure the power switch in the 0( off) position and unplug the water dispenser. Vertically insert the bottle into the supporter on top of the machine. Open the tap and let about 1 liter water flows into a container. Remove the water bottle from the dispenser. Place a large bucket beneath the drain outlet. Remove the drain cover and allow water to drain. After draining, replace the drain cover and you can use the machine. Attention: The dispenser heats water to a temperature of approximately 85°C. It can cause severe bums. Please operate it carefully.
3. Sanitizing: The machine should be disinfected with the disinfectant separately bought from drugstore or marketplace according to the instruction manual of the disinfectant and then clean it with water (see cleaning and draining instruction). Generally this should be done every three months
4. To Remove Mineral Deposits: Mix 4 liters water with 200g citric acid crystals, inject into the machine and make sure the water can flow out of the hot water tap. Switch on the power and heat it about 10 minutes, 30 minutes later, drain off the liquor and clean it with water for two or three times. Generally this should be done every six months. Never disassemble this machine by yourself to avoid danger damaging the machine.

SPILL FREE CAP INSTALLATION INSTRUCTION

INSTRUCTION

To maintain hygiene & prevent the plastic particles from entering the water dispenser tank, remove the plastic bottle cap and set the Spill Free Cap on the Mineral Water bottle and then place the bottle on the dispenser.

THANK YOU FOR TRUSTING DAWLANCE

This is your personal warranty from DAWLANCE (PVT.) LTD. It applies to you as the original purchaser. Provided, it is purchased from an authorized dealer and nor is it transferable.

1. YEARS COMPRESSOR WARRANTY: If the compressor of the Water Dispenser becomes inoperative as a result of defects in material or workmanship within 3 years of purchase, it will be replaced free of charge by a new or functionally operative compressor, only once. The cost of gas, parts, labour, home attending and transportation charges will be borne by the customer.
2. ONE YEAR PARTS WARRANTY: Any part of Dawlance Water Dispenser, which proves to be defective in terms of material or workmanship within one year of purchase, will be repaired or replaced with a new or functionally operative part free of charge.

WARRANTY TERMS & CONDITIONS

The warranty will be valid provided:

1. The warranty card has been properly filled and bears the dealer’s seal at the time of Unfilled or partially filled warranty cards and those with cutting and rewriting will not be entertained.

2. The Water Dispenser has not been repaired by any person other than a DAWLANCE CUSTOMER SERVICE CENTRE or AUTHORIZED CONTRACT WORKSHO

3. The Water Dispenser has been used with the original 3 pin plug connected to a properly earthed

4. The electric wiring has been provided with proper earth, a voltage stabilizer is used with Water
   The warranty will not be valid provided

5. Where defects have resulted from abnormal electrical load, short-circuiting, low or high voltage and poo

6. Where the Water Dispenser has been tampered with or altered in any way, or has been subject to misuse, negligence or accident, or has its serial number altered, disfigured

7. Damage is caused due to insect bites or Rodents (Mouse, Rat ).

LEGAL LIABILITY

• This warranty and the use of this product will be governed by Pakistani law.
• Any proceedings arising out of or in connection with this warranty or the use of the product may only be brought in a court of competent jurisdiction in Karachi.
• The company shall not be responsible for any loss or damage occurred to the property arising out of the use/operation of the product.
• The company shall not be responsible for any los or damage arising out of the use/operation or due to installation of the product.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>