Shenzhen Kingamei L9 Phone Stand With Bluetooth Speaker User Manual
- June 4, 2024
- Shenzhen Kingamei
Table of Contents
Phone Stand with Bluetooth Speaker
Model: L9
Instruction manual
Thank you for purchasing our product. In order to make full use of the new
Phone Stand with Bluetooth Speaker, we kindly invite you to read these
instructions prior to use.
Note: Before using this product, please use a Type-C cable to connect it
to the power source first.
Product Parameters
Product model: L9
Product material: ABS
Product weight: 370g
Type-c Input: DC 5V 1A
Power of the speaker: 4 03W
Battery capacity: 1800mah
Bluetooth name: Jteman MH669
Charging time: about 3-4hours
Product size:5.35×3.5×1.89 inches
Key Function
1. VOL+/Next
[Long press to Volume increase] [Short press to Next] 2. VOL-/Previous
[Long press to Volume decrease] [Short press to Previous] 3. Answer/Hang
up/Play/Pause
[Short press]| 4. Power ON/OFF
[Long press 3 seconds] 5. Microphone
6. Power on/off indicator
7. Charging indicator
8. Phone Stand
---|---
9. Device Charging interface
The mobile phone stand can be adjusted viewing angle
Features
- With the phone stand, free your hands
- Wireless Bluetooth Connection Support
- Bluetooth hands-free audio
- Stereo Speaker + Subwoofer
- Compatible with most the smartphones
How to use function keys
- Hold down the (4) for 3 seconds to enter Bluetooth pairing mode.
- Wait for ‘Jteman MH669’ to appear on your Bluetooth device list; Click it to pair with your cellphone.
- Short press 2 to Previous, Hold down the 2 for 3 seconds Volume decrease.
- Short press 1 to Next, Hold down the 1 for 3 seconds for Volume increase.
- When incoming calls ring, short press 3 to answer incoming calls, speaker through the built-in mic. The caller’s voice will come through the speaker. Music pauses during the call and plays again at the end of the call.
- Plug the Type-C cable into the 9 charging port, and then connect the Type-C end to an available power source to charge the device.
If you have any questions about this product, please contact us in time, and we will promptly answer you. Thank you.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet the general RF exposure requirements.
The device can be used in portable exposure conditions without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>