SAMSUNG DA97-17376B Refrigerator Water Filter Instruction Manual
- June 9, 2024
- Samsung
Table of Contents
SAMSUNG DA97-17376B Refrigerator Water Filter
A replacement for the following water filters:
Samsung filters
DA97-17376B, DA97-08006C, HAF-QIN, HAF-QIN/EXP
Tested and Certified by NSF International against NSF/ANSI Standard 42 in model AS-FF230 for the reduction of the claims specified on the Performance Data Sheet, and to NSF/ANSI 372 ( 0.25% lead).
Installation instructions
Before installation:
- Shutoff the cold-water supply to the refrigerator before installation. Turn on the refrigerator water dispenser to release water pressure, letting water drain from the pipe completely.
- It is normal for black carbon fines (particles) to appear on the outside of your filter. This happens when the filter is jarred in shipping. It is safe to simply wipe it off.
- The filter connectors are larger to prevent leaks. You might have to twist the filter hard to make sure the connection is secure.
- Shut off the water supply to refrigerator.
- Open the filter cover and turn the knob of the filter cartridge counter-clockwise by 90 degrees to unlock the old filter. Then pull it out.
- Insert the new filter cartridge and turn it clockwise to lock into place.
- Press and hold Filter Reset on the main panel for 3 seconds to reset the filter life.
- Open the water valve and run water through the dispenser for about 5 minutes (about BL) to remove any trapped air and clear the system.
Resetting your filter indicator
Note: These are the most common filter reset instructions. If the instructions don’t work for your refrigerator brand, see the documentation that came with your refrigerator.
| Refrigerator brand | Instructions |
|---|
Samsung systems
| Press and hold the ICE TYPE and CHILD LOCK buttons for three seconds. The water filter indicator should turn green.
Note: Only hold these buttons for three seconds. Holding these buttons for five seconds cancels the reset. If you cancel the reset, repeat the procedure.
Storage and maintenance
- Replace your filter every 6 months or 11 00L to prevent bacteria and fungus growth in your filter, supply lines, and storage tank.
- Keep your unused filters in a cool, dark, and dry place until you need them.
- If you do not use your water dispenser for more than four days, run two gallons of water before using it to prevent bad tasting water.
Frequently asked questions
- Q: Why is it difficult to twist the new filter into the filter housing?
- A: The connector may expand because of water pressure. Therefore, it is recommended you push the new filter in with a little bit of force, but not too hard. Then turn it clockwise.
- Q: Do I need to flush the filter aher installation?
- A: Aher installation, it is highly recommended you run water for a few minutes before using. Water filters are made from advanced coconut carbon block, so there are some carbon fines in the filter. Flushing removes the carbon fines to produce clean water.
- Q: Must the filter be changed every 6 months?
- A: Yes, you must replace the filter every six months or sooner if water flow is reduced or if there is heavy sediment.
Warning
To reduce the risk of property damage due to water leakage, this filter MUST
be installed in accordance with the manufacturer’s specifications and
instructions. This filter unit must be replaced every 11 00L or 6 months.
Failure to follow instructions and operating specifications will void your
warranty. Further, manufacturer assumes no responsibility or liability for
damages arising out of misuse of the product.
Samsung• is a registered trademark of Samsung Electronics Co., Ltd.
Samsung• is used for reference purposes only.
*The service life mentioned above is subject to chlorine reduction. Actual result varies according to the local water quality.
Operating specifications
- Operating Temperature: 33 -100° F/0.6 – 38°C
- Working Pressure: 20 -100 psi/140 – 689 kPa
- Rated Capacity: 316 gallons/1,196 litres
- Flow Rate: 0.5 gpm/1.9 lpm
Substance reduction
The system has been tested and certified by the NSF International according to
NSF/ANSI Standard 42 for the reduction of the substances listed below. The
concentration of the indicated substances in water entering the system was
reduced to a concentration less than or equal to the permissible limit for the
water leaving the system, as specified by NSF/ANSI Standard 42. While testing
was performed under standard laboratory conditions, actual performance may
vary.
Substance
|
Inf. Average
| NSF Specified Challenge Concentration| Ave.% Reduction(%)| Average Product
Water Concentration| Max Permissible Product Water Concentration| NSF
Reduction Requirements| NSF Test Report
---|---|---|---|---|---|---|---
ChlorineTaste and Odor| 2.1 mg/I..| 2.0mg/L± 10%| 97.0%| 0.063mg/L|
N/A
| >50%| J-00295502
Do not use with water that is micro-biologically unsafe or of unknown water quality without adequate disinfection before or aher the system. Systems certified for cyst reduction may be used with disinfected water that may contain filterable cysts.
Power Components B.V.
Bergweg 165A
3 707 AC, Zeist
The Netherlands
Email: info@allspares.com
Manufactured by Qingdao Ecopure Filter Co., Ltd in Qingdao, China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>