Electrolux Z931 Wet and Dry Vacuum Cleaner Owner’s Manual

June 9, 2024
Electrolux

Electrolux Z931 Wet and Dry Vacuum Cleaner

Please read these operating instructions before operating your vacuum cleaner.

Product and Accessories

CLEANING TOOLSElectrolux-Z931-Wet-and-Dry-Vacuum-Cleaner-FIG-
\(1\)

  1. Floor Nozzle
  2. Aluminium Telescopic Tubes*
  3. Flexible Hose
  4. Tools on Board
  5. On / Off Switch
  6. Cable Rewind Button*
  7. Power Plug
  8. Clasp
  9. Big Wheel
  10. Top Cover
  11. Drum

Applicable to model Z 931 only.
Line drawings are solely for illustration purposes and are subject to variations from actual product.

Dear Customers,
Dear Customer, please read through these operating instructions carefully.
Above all, please observe the safety instructions on the first few pages of this booklet. Please keep these operating instructions for future reference and pass them on to any subsequent owner of this appliance.
The safety standards of Electrolux electrical appliances are in keeping with the recognised rules of technology and the laws governing the safety of appliances. Prior to operating this appliance please familiarise yourself with the following safety instructions :

SAFETY INSTRUCTIONS

  • Read all the instructions and only use the appliance for its intendedpurpose.

  • The appliance must be switched off before plugging or unplugging it from the wall socket. Do not pull on the electrical cord to remove the plug from the wall socket.

  • Always remove the plug from the wall socket before attempting any form of user maintenance or cleaning, as specified in this booklet.

  • Do not handle the plug with wet hands.

  • Do not operate the appliance with a damaged electrical cord or plug. If the electrical cord is damaged it must be replaced by returning the product to an authorised

  • Electrolux service centre or similar qualified person to avoid a hazard.

  • If the appliance has malfunctioned or been damaged in any manner return the appliance to the nearest authorised Electrolux service centre for examination, repair or adjustment.

  • Do not carry or drag the appliance by the electrical cord.

  • Keep the electrical cord away fromheat, oil, sharp edges and rough or hot surfaces and do not run the appliance over the cord.

  • Hold onto the plug when rewinding the electrical cord to prevent the plug from whipping or hitting hard against the appliance.

  • An extension electrical cord may be used provided that it has a higher rating than the appliance. Please refer to the information provided on the appliance’s rating plate or consult your nearest authorized Electrolux service centre.

  • To protect against electric shock do not immerse the electrical cord, plug or the appliance in water or other liquids.

  • Do not expose the appliance to rain.

  • Do not use the appliance outdoors.

  • Never leave the appliance running unattended.

  • This appliance is not intended for use by person (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
    Children should be supervised to ensure that they do not play with the appliance.

  • Store the appliance away from high heat sources.

  • Do not use this appliance to vacuum up the following :

    • Inflammable or combustible substances,
    • Hard pointed objects,
    • Hot ash, lighted cigarette ends or anything that is burning or smoking. Large quantities of fine dust e.g. lime, cement or plaster dust, toner dust from laser printers etc.
  • Do not operate this appliance in areas where the substances listed above may be present.

  • To prevent the reduction in air flow, ensure that all orifices/vents on this appliance are kept free from blockages and do not insert any objects into these orifices/vents.

  • Do not use without dust bag and filters In place.

  • If the motor overheats, it will rum off automatically. If this occurs, press the on off button and wait for a few minutes before SWitching on again.

  • Extra care should be taken when vacuuming staircases.

  • It is dangerous to alter the specifications or modify the vacuum cleaner, only use accessories recommended by Electrolux.

  • Under no circumstances should the customer attempt to repair the vacuum cleaner.

  • The vacuum cleaner should only be repaired and/or serviced by an authorized Electrolux service centre and only genuine Electrolux spare parts should be used. Failure to do so may render the warranty void.

This vacuum cleaner is for household use only

Important I
This vacuum cleaner must only be connected to a power aupply whose voltage and frequency comply with the specifications given on Iha appllance radng plate.

Quick Guide
When taking the product out of its packaging, check for damages.

VACUUM CLEANER ASSEMBLING

Always remove the plug from the power supply before fitting or removing accessories. Before putting the appliance into the service, please check If all filters are Inserted correctly

Connecting vacuum cleaner
Finding or removing the flexible hose to the air Inlet

  • Fit the flexible hose into the air inlet. Tum the hose grip clockwise until it clicks into position.
  • To release, first remove the plug from the power socket. Detach the flexible hose firmly from the air intake duct by turning anti-clockwise

Fitting or removing the flexible hose to the air outlet

  • Remove the filter cover and the fliter.
  • Fit the flexible hose into the air outlet.
  • Turn the hose grip clockwise until it clicks into position.
  • To release, first remove the plug from the power socket. Detach the flexible hose firmly from the air outlet duct by turning anti-clockwise.

Fitting the extension tubes and accessories

  • Fit the extension tube to the handle.
  • Fit the brush to the extension tube.

Fitting a chosen nozzle

  • Floor brush is intended for cleaning hard floors and carpets.
  • Crevice/upholstery nozzle is for cleaning corners and cushions.
  • Use the wet nozzle only for cleaning wet surfaces.

Instructions for Use

CLEANING TOOLS

The crevice tool, dusting brush and upholstery nozzle are stored on the accessories holder.

Floor Brush

  • ldeal for the daily cleaning on carpets and hard floors.
  • For the carpet
  • For the hard floor

Wet Nozzle

  • ldeal for absorbing water or liquid.
  • Wet nozzle to absorb water

Crevice Nozzle
The crevice nozzle can be used for cleaning corners, between cushions or difficult to reach places.

Dusting Brush

Dusting brush is used for the furniture, venation, blinds, books, lamp shades and shelves.

Upholstery Nozzle

The small brush is used for cleaning the sofa.

Operating Procedure

  • Before using the appliance, pull out a sufficient length of cord and insert the plug into the power supply.
  • Press the On/Off button to switch the unit on. lo stop it, press the On/ Off button again.
  • Use the Electronic Power Switch to control the suction of the cleaner. (Cord winder applies to model Z 931)
  • To rewind the cord, press the rewind button and guide the cord with hand to ensure that it does not whipP causing damage.
    (Cord winder applies to modelZ 931)

VACUUMING DUST

Before vacuuming dust, please make sure the body, motor housing, filter cylinder and attachments are dry.

Please ensure the filter cylinder is fitted.
Always operate the cleaner with dust bag installed. Undo the clasp and remove the top coverfrom the body. Secure the dust bag in its position by pushing down the bag collar in its slot.

ABSORBING WATER

  • Before you use the vacuum to absorb water or liquid, please make sure the flter cylinder is fitted on the motor housing.
  • Remove the dust bag from the vacuum cleaner.
  • You may fit in the wet nozzle or other cleaning tools.
  • The safety buoy will not work when the body is filled with liquid. Please
  • Switch off the unit and remove the top cover. Pour out the liquid.
  • If the appliance has fallen over, water may enter into the motor. Ensure that there is no water inside the motor betore operating again.

BLOWING DUST

  • Remove the filter grille from the blower position.
  • Fit the hose connection.
  • Once complete, remove the hose connection, fit the filter grille to its position and turn tightly.

Note : When the vacuum cleaner is working, the suction may get weak. Now you should turn off the unit for a moment. If it still does not work, clean the body after turning off the unit. Continuous use of appliance may increase the motor temperature and may damage the unit.

Maintenance

DUST BAG REPLACEMENT

Note:
Before doing any type of cleaning or maintenance to the cleaner, always ensure that the cleaner is unplugged from the wall socket.

  • After detaching the flexible tube, remove the top cOver
  • Lift up the dust bag collar to remove from its slot.
  • when the dust bag is full, replace with a new one.
  • Replace the top cover and secure both latches on each sides.

CLEANING FILTER

  • Filter must be cleaned at least twice a year or when it becomes visibly solid.
  • Disconnect from electrical outlet before cleaning filters.
  • Do not use a washing machine to rinse filters.
  • Do not use hair dryer to dry filiters.
  • Remove filterElectrolux-Z931-Wet-and-Dry-Vacuum-Cleaner-FIG- \(17\)
  • Rinse filter in lukewarm water and dry the filter completelyElectrolux-Z931-Wet-and-Dry-Vacuum-Cleaner-FIG- \(18\)
  • Replace the filiter

How To Store Your Vacuum

  • Choose a storage location that isboth safe and dry.
  • The vacuum comes with an onboard tool coupling for storing the fioor nozzle, slide the parking clip onto the parking positions on the cleaner.
  • Keep the extension tubes, nozzles and hose together to avoid losing them.

TROUBLESHOOTING

In case of malfunction, check for the following probable reasons. Make the necessary corrections which may be perfomed at home. If the problem persists, consut the Electrolux Authorized Service Centre.

PROBLEM POSSIBLE CAUSES CORRECTIONS
The vacuum cleaner The plug is not properly Check the plug connection
does not start. connected to the socket. or try another socket.
  Thermal protector Press the ON/ OFF button
  activated due to motor and wait 30 minutes for the
  high temperature. motor to cool off.

Filter indicator lights and stays on.

|

Dust bag is full.

The filters are clogged.

|

Replace disposable dust bag and check filters.

Clean or replace filters.

Reduction of| Suction hose blocked.| Clean the hose.
suction capacity.|  |
 | Nozzle blocked.| Clean the nozzle.
 | Disposable dust bag| Replace disposable dust bag.
 | is full.|
 | Filters clogged.| Clean or replace filters.
 | Damaged or broken hose.| Replace the hose.

Over heating.

|

Disposable dust bag is full.

Filters are clogged .

|

Replace the disposable dust bag.

Clean / replacefilters.

Technical Data

For Z930 & Z931

  • 220-240V, 50/60Hz
  • Max Power (W): 160OW

MALAYSIA
Electrolux Home Appliances Sdn Bhd Lot C6, No. 28, Jalan 15/22, Taman Perindustrian Tiong Nam, 40200 Shah Alam, Selangor Malaysia
Customer Care Hotline : 1300-88-11-22
Customer Care Services Tel : (+60 3) 5525 0800
Customer Care Services Fax: (+60 3) 5524 2521
Email : malaysia.customercare@electrolux.com
Website : www.electrolux.com.my

VIETNAM
Electrolux Vietnam Ltd Floor 9th, A&B Tower 76 Le Lai Street Ben Thanh Ward – District 1Ho Chi Minh City Vietnam
Tel: +(84) 8 3910 5465
Fax: +(84) 8 3910 5470
Customer Care Services : 1800-58-8899
Email: vncare@electrolux.com
Website : www.electrolux.vn

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals