JOYWHALE BW-A20 24V Kids Ride on 2 Seater ATV Car 4WD Quad Electric Vehicle Instructions

JOYWHALE BW-A20 24V Kids Ride on 2 Seater ATV Car 4WD Quad Electric

Vehicle

SAFETY

• NOTE For best performance, only use this vehicle on flat and hard surfaces
• AGE RANGE 3 to 8 years old
• WEIGHT CAPACITY 130LBS (59KG) is the maximum weight for 2 riders

WARNING

• This product contains small parts. Keep child ren away during assembly. Make sure to remove all packaging material and parts from underneath the vehicle body.
• Never open the battery. Batteries contain lead and lead compounds (acids).
• Limbs, hair and clothing can get caughtin moving parts. Always wear shoes, keep limbs away from moving parts and do not wear loose clothing while operating this vehicle.
• This vehicle does not have separate braking system. Do not leave a child unattended during operation. Do not use it in a location that may require emergency stop function as this could result in loss of control, which may cause serious injury or death.
• Use of this vehice near streets, motor vehicles, steps, bodies of water, sloped surfaces, hills, wet areas, flammable vapors, in alleys, at night or in the dark could result in an unexpected accident.
• Use of this vehicle in unsafe conditions such as snow, rain, loose dirt, mud, sand or gravel may result in an unexpected accident such as tipping over and could damage the electrical system or battery.
• Do not operate this vehicle in an unsafe manner. Examples include but are not limited to
  • Pulling the vehicle with another vehicle or similar device
  • Allowing more than two children to ride
  • Pushing the user
  • Traveling at an unsafe speed
• Use of a battery or charger other than the supplied rechargeable battery and charger may cause a fire or explosion. Only use the supplied battery and charger.
• Use of the rechargeable battery and charger for any other product may result in overheating, fire or explosion.
• Never use the supplied rechargeable battery and charger with another product.
• Explosive gases are created during charging. Charge the battery ina well ventilated area. Do not charge the battery near heat or tlammable materials.
• Contact between the positive and negative terminals may result in fire or explosion. Avoid direct contact between the terminals. Picking up the battery by the wires or charger can cause damage to the battery and may result in a fire. Always pick up the battery by its case or handles.
• Liquids on the battery may cause fire or electric shock. Always keep all liquids away from the battery and keep the battery dry. Contact or exposure to battery leakage (lead acid) may cause serious injury. If contact or exposure occurs immediately call your physician. If the chemical is on the skin or in the eyes, flush with cool water for 15 minutes. If the chemical was swallowed, immediately give the person water or milk. Do not give water or milk if the patient is vomiting or has a decreased level of alertness. Do not induce vomiting.
• Battery posts, terminals and related accessories contain lead and lead compounds (acid)
• Never leave a child unattended.
• Always sit in the seat when using this vehicle.
• Keep your hands, hair and clothes away from moving part.
• Always wear shoes when operating this vehicle.
• Children under 3 years of age cannot use the vehicle.
• Only drive on level ground.
• Do not go near swimming pools or other bodies of water, drop-offs or up and down steep inclines.
• Do not drive the vehicle into loose dirt, mud, sand, fine gravel or on wet surfaces.
• Do not drive the vehicle on streets or near cars.

TOOLS REQUIRED

PRODUCT ASSEMBLY

1. Part 1® Fix the dashboard

   • Clip the dashboard into the body.
   • Fix with M4*12mm screws.

2. Part 2 ® Fix the central control

   • Take the center control out of the body hole.
   • Use scissors to cut the tie for fixing the harness.
   • Clip the central control into the body slot as shown in the figure.

3. Part 3 Fix the front bumper

   • Clip the front bumper into the body.
   • Fix with M4*12mm screws.

4. Part 4 Fix the steering lever

   • Take 10 insert the washer into the steering lever.
   • Clip the steering lever into the body.

5. Part 5 Fix the square tube

   • Clip the square tube into the body.
   • Fix with M4*12mm screws.

6. Part 6 Fix the four drive front bracket

   • Insert bearing into the four drive front bracket.
   • Insert the four drive front bracket into the body square tube.

7. Part Fix the four drive front bracket

   • In turn put the o10 washer and nut into the fou drive front bracket.
   • Fix the nut with the M10 wrench.
   • AS shown in the figure: Connect the motor Wires.

8. Part 8 Fix the rear axle

   • Insert the rear axle into the car.

9. Part 9 Fix the gear box (L/R)

   • Put the drive motor into the rear axle, and stuck the motor into the body slot. (Tips: gear box left right distinction)

10. Part 10 Put the wheel, wheel hub, gasket and nut into the front axle in turn. Fix The nut with the M10 wrench and then attach the wheel cover to the wheel. Place the wheel, wheel hub, gasket, and nut on the rear axle in turn Fix the nut with the M10 wrench and then attach the wheel cover to the wheel.

11. Part 11 Fix the steering wheel.

    • Remove the nut and bolt from the steering wheel.

    • Insert the steering wheel over the steering and secure with nut and bolt.
      Open the seat

    • Find the rear motor plugs (L/R), and connect them to the plug on the receiver respectively. (the plug on the receiver is not differentiated between left and right)

    • Find the main power cord plug of the battery and insert it into the corresponding socket of the receiver.

    • Battery.

12. Part 12 Fix the seat.

    • Clip the seat into the body.
    • Rotate the latch on the seat to secure the seat.

13. Part 13 Fix the backrest.

    • Clip backrest into the body.

DASHBOARD DIAGRAM

1. Pedal: Press, the vehicle will move when the power is on; release on the move, the motors will generate resistance to stop the vehicle.
2. Control board.
3. Power button: Long Press it 3 seconds. Turn the vehicle on and off.
4. Wireless Technology(YX): Press thebutton to enter, and you car hear the “Du” sound. Then select the device named “YX” on your mobile phone. The device prompts “connected,” which means the pairing is successful. After connected, the car can play music trom your mobile phone.
5. F: Radio, long press it 2-3 seconds, the light of FM button will flash and Automatic search, when the search completes, the FM key stops flashing.
6. Music Button: play music.
7. Last song: Switch songs/ and long press will decrease volume.
8. Forward button: Press it, go forward.
9. Backward button: Press it, go backward.
10. Speed button: Press it, choice high speed or low speed.
11. Next song: Switch songs/ and long press will increase volume.
12. U.
13. Socket: Charge.
14. Power display: Clearly see the battery power, in order to charger in time.

CHARGING INSTRUCTIONS

1. OInsert the charger jack into the charging hole of the car.
2. Plug the charger plug into the stable matching AC power supply as shown in the picture.
   • Charge the battery 15 to 18 hours before initial use.
   • On average, you will need to charge the battery between 8 and 12 hours. Do not charge the battery for more than 20 hours. Failure to charge the battery as directed could cause permanent damage to the battery and void the warranty.
   • Damage to the battery may occur if it is allowed to drain completely. Do not allow the battery to drain completely.
   • Check the battery and charger (supply cord, connector) for wear and damage before charging. Do not charge the battery if damage has occurred.
   • Only an adult who has read and understood the safety warnings should handle, charge and recharge the battery.

MAINTENANCE

The vehicle should be checked for damage, missing or badly worn parts before use.

• Check the tightness of the fasteners before each use.
• Check the tightness of the wheels.
• Ensure the battery is securely in place before use.
• Occasionally use lightweight oil to lubricate moving parts such as wheels and steering linkage.
• Do not use oil on plastic or nylon parts. No lubrication is required.
• Store the vehicle indoors or cover it with a tarp to protect it from the wet weather. Keep it away from sources of heat, such as stoves and heaters.
• Clean the vehicle with a soft, dry cloth. To restore shine to plastic parts, use a non-wax furniture polish. Do not use car wax, abrasive cleaners or wash the vehicle with soap and water. Water will damage the motor, electrical system and battery.
• Joy whale recommend you ask professional advice from our technical team if you need maintenance or repair service. Official email address of Joy whale: care@joywhale.com

TROUBLESHOOTING

CARING FOR YOUR RIDE-ON

• Park the vehicle indoorS or cover it with a tarp to protect it from wet weather.
• Do not leave the vehicle in the sun for long periods of time or fading may ocCur. Store in shade or cover with tarp.
• Do not wash the vehicle witha hose.
• Do not wash the vehicle with soap.
• Charge battery at least once a month to prolong the life of the battery.

If you have any questions about the steps of installing the product or if there are any problems with the product in use, please feel free to contact the customer service of your purchase platform by email.

WARNING

The battery on the vehicle is not replaceable.

• Do not mix old and new batteries.
• Do not mix alkaline, standard(carbon-zinc) or recharge able batteries.
• Non-rechargeable batteries should not be charged.
• Rechargeable batteries should be charged under adult supervision only.
• Exhausted batteries should be removed.
• The supply terminals should not be short-circuited.
• Do not put batteries next to or in a heat source(fire, electronic heating device, etc.).
• Do not hit batteries against hard objects.
• Do not submerge batteries in water.
• Batteries should be inserted with the correct polarity.

IMPORTANT

• Always charge battery for 4-6hrs the first time you use it.
• Always charge battery for 8-12hrs after each use.
• Charge the battery once a month, even if you are not using your vehicle.

WARNING

• Protective equipment should be worn. Not to be used in traffic.

• The toy should be used with caution since skill is required to avoid falls or collisions causing injury to the user or third parties.

• To reduce the risk of injury, adult supervision is required. Never use in roadways, near motor vehicles, on or near steep inclines or steps, swimming pools or other bodies of water, always wear shoes, and never allow more than two riders.
  CHOKING HAZARD-Small parts.

• Not for children under 3yrs.

• To reduce the risk of injury, adult supervision is requirde. Never use in roadways. Never motor vehicles, on or near steep inclines or steps, swimming poors or other bodies of water; always wear shoes, and never allow more than two riders

• ADULT ASSEMBLY REQUIRED

• Not to be used in traffic

CARING FOR YOUR RIDE-ON

Caution: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not instaled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,

The user is encouraged to try to correct the interference by one or more of the following. Measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>