Siemen RNI-CAB-BRKT Mounting Plate and System Cable Kit Instruction Manual
- June 9, 2024
- Siemen
Table of Contents
Siemen RNI-CAB-BRKT Mounting Plate and System Cable Kit
Installation Instructions
Model REMBOX2-MP/REMBOX4-MP
REMBOX Mounting Plate
INTRODUCTION
The REMBOX2-MP and REMBOX4-MP Mounting Plates are used in REMBOX2 and REMBOX4 enclosures respectively for mounting OCM-16 and SIM-16 modules. Up to 4 OCM-16 or SIM-16 modules can be mounted on a REMBOX2-MP; up to 8 OCM-16 or SIM-16 modules can be mounted on a REMBOX4-MP.
INSTALLATION
Remove all system power before installation, first battery then AC. (To power
up, connect the AC first, then the battey.)
Refer to Figure 1 on page 2.
- Holding the REMBOX2-MP/REMBOX4-MP in your hands, place the four ¼” holes on the REMBOX2-MP/REMBOX4-MP Mounting Plate over the four threaded studs in the bottom of the enclosure.
- Secure in place with the #8-32 nuts supplied.
- Place the mounting holes in the OCM-16 and/or SIM-16 modules over the mounting holes on the REMBOX-MP.
- Secure the OCM-16 and/orSIM-16 modules to the REMBOX-MP using the screws provided.
COMPATIBILITY
The REMBOX2-MP can only be used in a REMBOX2 enclosure.
The REMBOX4-MP can only be used in a REMBOX4 enclosure.
SPECIFICATIONS
REMBOX2 Mounting Plate: 11.25”W x 9”H
REMBOX4 Mounting Plate: 20.875”W x 9”H
Siemens Industry, Inc. Building Technologies Division Florham Park, NJ
P/N 315-096357-6
Siemens Canada Limited
Building Technologies Division
2 Kenview Boulevard
Brampton, Ontario L6T 5E4 Canada
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>