Husqvarna 40-C80 Charging Rail User Manual
- June 9, 2024
- Husqvarna
Table of Contents
Husqvarna 40-C80 Charging Rail
WHAT IN BOX
INSTALLATION INSTRUCTION
safety Instruction
CAUTION!
When the product is used with 8 pieces of 40-C80 battery chargers, the maximum current rating is 13.6 A when the mains voltage is 90–125 V and 6 A when the mains voltage is 207–240 V.
- Use only Husqvarna battery charger 40-C80 with the charging rail.
- Read all safety warnings and instructions for the 40-C80 battery charger before you use the charging rail.
- Do not use the power cord for other operations.
- Make sure that the wall can hold loads of minimum 30 kg.
- The screws that are included with the product can be used for wall installation of the rail. Make sure that the screws are applicable with your wall type.
- Do not use an electric screwdriver to install the battery charger to the charging rail. An electric screwdriver can cause damage to the battery charger.
- Do not move the charging rail when the batteries are connected to the battery chargers.
- Do not touch the cable connectors when they are connected to a power outlet.
- Put the cable connectors that are not in operation in the rail pocket to prevent damage.
- Do not pull the power cord.
- Do not use the power cord if it is damaged.
- Do not try to repair a damaged power cord.
- Do not use rubber feet that are delivered with the charging rail for wall installation. It can cause damage to the charging rail.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>