havit HV3601T-BTK Taper Wall Light Instruction Manual
- June 4, 2024
- havit
Table of Contents
Taper Wall Light Installation Instructions
Product Specifications
Model No. | HV3601T-BLK | HV3601T-WHT | HV3601T-SS316 | I HV3601T-CP |
---|---|---|---|---|
Name | Taper | |||
Material | 316 Stainless Steel | 316 Stainless Steel + Copper | ||
Colour | Black | White | Stainless Steel | Copper |
IP Rating | IP44 | |||
Input Voltage | 240v AC | |||
Protection Class | (Requires Earth) | |||
Lamp Base | 0.00E+00 | |||
Lamp Wattage | ||||
Colour Temp | TRI Colour – 3000k, 4000k, 5500k | |||
Lumens | 7001m, 7201m, 7401m | |||
CRI | >80+ | |||
Wiring | Parallel | |||
Dimmable | No | |||
Warranty | 3 Years Replacement* |
Important Safety Issues:
-
This product must be installed by a qualified electrician according to AS/NZS 3000.
-
Ensure all electrical mains are disconnected before any installation.
-
Modification of this product will void any warranty.
-
Must not exceed maximum wattage – 60w E27
-
Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
-
When installing copper fittings, gloves must be worn to avoid any oils transferring to the fitting.
-
All 316 & 304 stainless steel fittings must have regular cleaning maintenance to avoid any tea staining from forming on the fitting.
(Warranty does not cover Tea Staining) -
All o-rings and seals must be in place correctly to maintain a warranty
-
This form may be updated at any time due to product improvements, please check the online installation form for the most current version.
Steps for Installation:
- Make sure that the electrical circuit is free of voltage (master switch off)
- Remove the screws from the side of the fitting and remove the cover and set aside
- Install base plate to the wall in the desired location
- Seal all holes including cable entry and mounting holes
- Connect the cable – use wire with earth; connect the earth first, then live and neutral wire
- The Colour temperature is set to 3000K. To change, Remove the globe by twisting anti-clockwise and selecting desired color temperature by moving switch on side of the globe and then reinsert the globe.
- Reattach cover to base plate making sure screws are tight to avoid water penetration
- Apply silicon around the edge of the fitting to prevent any water from getting inside to electrical connections.
- All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Steps for Changing Globe:
- Remove the cover from the fitting by removing the 2 screws and removing the cover
- Remove the globe by twisting anti-clockwise.
- Re-insert the appropriate globe by twisting clockwise into the lamp holder (Make sure not to exceed max wattage, see product label for correct info)
- Reattach cover to base plate making sure screws are tight to avoid water penetration
- Apply silicon around the edge of the fitting to prevent any water from getting inside to electrical connections.
Must be installed by a licensed electrician
**Warranty Terms & Conditions*** | Additional Information |
---|
|
https://havit.com.au/pages/warranty-terms-and-conditions|
https://havit.com.au/
Contact Details:
143 Beauchamp Road
Matraville NSW 2036
Australia
Tel: 02 9381 8300
Fax: 02 9666 8881
Email: sales@havit.com.au
Web: www.havit.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>