JJRC Products XXD184 Induction Aircraft Instruction Manual
- June 9, 2024
- JJRC Products
Table of Contents
INDUCTION AIRCRAFT OPERATING INSTRUCTIONS
TECHNICAL DATA OF TRANSMITTER
- Type of Battery: 1.5V AAA non-rechargeable
- Number of Battery: 3x 1.5V AAA
- While in its low-voltage protection, indicator light flashes slowly, and transmitter cannot be used. Please replace your battery at this time.
- NOTE: Transmitter does not have a built-in battery
TECHNICAL DATA OF AIRCRAFT
- Length: 170mm
- Width: 170mm
- Height: 38mm
- Battery Capacity: 3.7V 550mAh
- Charging Time: 60 mins
- Flight lime: 6 mins
- Remote Control Distance: 80 m
Thank you for purchasing our product. You must understand how it works and you must use it in a safe manner.
Please read this manual carefully before flying, and please keep it properly for future reference. As inconsistent with the specification in pictures, please prevail in kind.
GETTING TO KNOW YOUR TRANSMITTER
PREPARING FOR FLIGHT
- Place the aircraft in a flat position and turn on the power switch.
- Turn on the power switch of transmitter, and push the left directional control joystick up and down, the aircraft light will always be on when the link is successful, short press the one-key calibration button on the remote control.
- Start flying, press the One Key Take-off button on the transmitter quickly, and the aircraft takes off to 1.2 meters.
OPERATING METHOD
- When the aircraft is in flight, steer the right direction lever on the transmitter, when the lever is pushed fonvard/backward, it will move forward/ backward. and when the lever is pushed left/right, it will fly left/right.
- When the aircraft is in flight, steer the left direction lever on the transmitter, when the lever Is pushed forward/backward, it will fly up/down, and when the lever is pushed left/right, it will turn left/right.
- When the aircraft is In flight, can be used with the left and right direction control levers in the remote control, when the left and right control sticks are pushed forward at the same time, the aircraft will fly forward while flying upwards(As shown 1). When the left and right joysticks are pushed to the left at the same time, the aircraft will fly to the left while turning to the left(As shown 2). Arbitrarily cooperate with the four directions of the left and right control levers on the remote control to realize the steering flight function in the corresponding direction.
MAIN FUNCTION
- Rollover stunt/obstacle avoidance While the aircraft is in flight, press the rollover stunt button on the remote control, the aircraft indicator flashes, and move the control lever in four directions to realize the rollover function in the corresponding direction. Long press for 3 seconds, the aircraft will turn on the obstacle avoidance function, and long press for 3 seconds wain to turn it off.
- One key return While the aircraft is in flight, press the one key return button on the transmitter quickly, the aircraft automatically returns to the direction the remote control was In when taking off.
- One key take-off/landing After linking, short press the one-key take-off button on the remote controller, the aircraft will take off at speed, long press for one-key lancing, and the aircraft will land at speed.
- Fast rotation function While the aircraft is in flight, push the left direction control stick to the left or right for three seconds, and the aircraft will quickly rotate in the direction of the push.
- Balance settings While the aircraft is in flight, when the fuselage is unbalanced, when tilting fonvard/backward. press the backward trimming/forward trimming button on the remote control to balance the aircraft. When tilting to the left/right, press the right trimmingffeft trimming button on the remote control to balance the aircraft.
- Fligh/Low speed switch Press the High/Low Speed Switch on the transmitter to control the flying speed of aircraft.
- Headless mode/Light control switch When the aircraft is in flight, press the headless mode button on the remote control. No matter whether the aircraft head turns to any direction, the front of the aircraft will be locked to the forward flight direction. Short press again to cancel the headless mode. Long press the headless mode button on the remote control for 3 seconds, the aircraft will turn on the control light, and long press for 3 seconds again to turn it off.
- One key calibration Place the aircraft in a flat position and press the one-key calibration button on the remote control. LED light of the aircraft will change from steady on to fast flashing. and the aircraft has been calibrated successfully.
- Low-voltage protection When the aircraft is enabled for low voltage protection, its indicator flashes slowly, and after about 30 seconds, it slowly descends to the ground and stops flying.
NOTE: After starting the aircraft, press the power button again to turn it off. At the same time, press the Power OFF/ON button on the transmitter again.
MAINTENANCE
- The product shall be cleaned regularly with a clean soft cloth.
- Avoid strong sunshine or heat.
- Do not immerse the product in water, so as to prevent damage to electronic components.
- Regular check of plugs and other accessories is suggested. If damaged, have it repaired before use.
SAFETY REGULATIONS
- Small parts of the aircraft shall be well kept away from children to avoid accidents.
- The aircraft is full of power. It is suggested to slowly push up the left-hand gear shift lever of transmitter during the first flight to avoid any potential collision damage of high speed.
- 1t is suggested to switch off the power of the transmitter before the aircraft after completion of flying.
- The batteries shall be kept away from high temperature or hot conditions (such as fire or near electric heating devices).
- Pay attention to the operating of the aircraft in a wide open area with no obstacles to avoid hitting the head, face or body of others when the aircraft is flying and landing.
- Chikl shall be under the monitoring of an adult while playing the aircraft to ensure that the aircraft is controlled within the sight of operator (or Instructor).
- 1t is prohibited to charge non-rechargeable batteries. Batteries shall be installed or replaced In correct direction; it Is not allowed to mix old and new or different types of batteries.
- Tum off the power of the transmitter and the aircraft, and remove batteries from the transmitter when not in use for an extended period of time.
- Be aware of the risk of a short circuit at the power terminals.
PRECAUTIONS
- Low power of the transmitter or the aircraft will affect the remote control distance.
- Low power of the aircraft will lead to difficulties in taking off or ascending.
- If the aircraft is damaged or deformed, please repair it in time. In serious cases (for example, blades are broken or damaged), it may cause injury.
- Please remove batteries from the transmitter if not in use for a long time in case of battery leakage.
- Do not allow the aircraft to crash from high altitude or severely collide, as this will damage the aircraft or shorten its service life.
- Alloy parts in the aircraft may hurt your children, please pay more attention to them.
The statements should be cis played in the user manual: changes or
modifications not expressly approved by the party responsible f or corn
pliance could void the users authority to operate the equipment.
This equipment has been tested and found to comply with the limits f or a
Class B digital device, pursuant to Pat 15 of the FCC Rules. These rim Its are
designed to provide reasonable protection against harmful Interference In a
residertial installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. H
weever, there Is no guarantee that lrterference will not occur In a panicLiar
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user Is encouraged to try to correct the interference by ore or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced rattorIV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located a operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>