VOLTECK VENT-56 Ceiling Fan Instruction Manual

: June 9, 2024
: VOLTECK

Table of Contents

Instructive
TECHNICAL PARAMETER
ASSEMBLY
INSTALLATION OF THE CONTROL
CLEANING
Read User Manual Online (PDF format)
Download This Manual (PDF format)

VOLTECK VENT-56 Ceiling Fan Instruction Manual

Instructive

READ THESE INSTRUCTIONS BEFORE INSTALLING Before installing, disconnect the power supply with the circuit breaker or fuse. Ensure that the circuit is not energized and that the area is free of humidity before starting the installation

CAUTION

The ceiling hook must be properly installed, all wiring must be done by a qualified electrician. Do not install the fan too close to the front door, there should be at least 3 ft from the end of the blades. Install the fan high above the floor, at least 10 ft above the floor. Never try to stop the fan blades while they are running

TECHNICAL PARAMETER

127 V~ 60 Hz 65 W

Air flow: 10 444 mm3/h
Speed: 300 r/min (RPM)
Maximum area: 15 m2 – 20 m2
Thermal insulation class of the motor windings: Class E Indoor use.
Electric power consumption
Energy consumption: 1 560 Wh/day
Per unit of time under conditions
normal operation of the appliance.
Standby power consumption : Not applicable In unit of device time
Based on 24 hours of continuous use

ASSEMBLY

Pass the cables through the pipe.
Install the tube on the motor shaft and secure in place using the screws and bolts. (a single washer, lock washer, nut and cotter).
Firmly tighten the screw and bolt using a screwdriver or wrench as shown. Failure to tighten firmly will cause abnormal noise, vibration or shorter product life.
Insert the cables into the connector and tighten.
Then place the upper and lower covers on the pipe.
Fix the hook to the ceiling using screws separate from the connection box. Then assemble the tube on the hook.
Fix the covers using a screwdriver.

INSTALLATION OF THE CONTROL

Unscrew the control cover.
Connect the wires through the input hole as shown in the diagram.
Mount the control on the wall or on a wood block.

CLEANING

Use only a soft cloth.
Do not use solvents or chemical products.
Never let liquids penetrate the product.

This product is not intended for use by persons (including children) whose physical, sensory or mental abilities are different or reduced, or who do not have experience or knowledge, unless such persons are supervised or trained in the operation of the device by a person responsible for their safety. Children should be supervised to ensure that they do not use the devices as toys.
Symbols