Artemide Tolomeo Double Shade Suspension Light Instructions
- June 9, 2024
- Artemide
Table of Contents
Artemide Tolomeo Double Shade Suspension Light Instructions
Note:
Prior to any work on the fixture always switch off the mains.
Attention:
Only use bulbs of the type and wattage indicated on the rating plate.
Assembly instructions.
Completely unscrew the locking ring A. Keeping the rod B with a hand screw the extension cable C on the joint D. Screw the locking ring P. Couple up steel cables O to joint D. In order to facilitate this operation it is advisable to bring the two arms near rod B as described in figure. Separate bottom plate cover E from bottom plate F with a screwdriver. Pass cables proceeding from ceiling through hole G and fix bottom plate F by loops H. Untighten the screw Q to separate the square R from the bottom plate F. Carry out electrical connections to terminal strip by connecting earthing cable to screw L marked with the symbol . Reassemble the square R and tighten the screw Q. Unscrew locking ring A and adjust lamp height and direction. If necessary, loose cable- -clamp M and shorten feeding cables N. Attention: keep a cable length enough to move the lamp in all its positions (the zones with the letter Z should have a certain cable extension). Reposition bottom plate cover E. Adjust the lock rings S to increase or decrease the device movement stiffness.
Instructions for mounting to wall box: Completely unscrew the locking ring A. Keeping the rod B with a hand screw the extension cable C on the joint D. Screw the locking ring P. Couple up steel cables O to joint D. In order to facilitate this operation it is advisable to bring the two arms near rod B as described in figure. Separate bottom plate cover E from bottom plate F with a screwdriver. Make the electrical connections by connecting the WHITE wire from the fixture to the WHITE wire from the wall box and the fixture BLACK wire to the BLACK wire. Also connect the GREEN wire from plate to the system ground conductor. Fix rose to wall box. Unscrew locking ring A and adjust lamp height and direction. If necessary, loose cable- -clamp M and shorten feeding cables N. Attention: keep a cable length enough to move the lamp in all its positions (the zones with the letter Z should have a certain cable extension). Reposition bottom plate cover E. Insert bulbs.
To install the diffuser T, loosen the lock ring V. Install the diffuser T and re- -tighten the lock ring V. Tighten the bulb. Note: use a brush to clean the diffuser. Do not use water or detergents.
Bulbs:
2x150W IAA E27
2x150W IAG E27
2x150W HSG E27
For USA and
Canada only:
2x150W
type A—G—T10
E26
The symbol indicates the suitably of fixtures to be mounted directly on normally inflammable surfaces. Fixtures without the above symbol are only suitable for installation on non- -inflammable surfaces.
All ARTEMIDE products falling within the range of application of the European low voltage directive B.T. 73/23 and subsequent amendment 93/68, meet the required specifications and bear ” ” labelling.
ARTEMIDE spa not shoulder any responsibilities should products be modified without prior authorisation.
Attention: This equipment is guaranteed only when used as indicated in these instructions. Therefore they should be kept for future reference.
In case of complaint, please quote number
via Bergamo, 18- -20010 Pregnana Milanese (Milano)- -ITALIA tel:93.51.81- -(a ricerca automatica) telefax 02/93.59.02.54- -93.59.04.96 sito internet http://www.ARTEMIDE.COM codice fiscale e partita I.V.A. 00846890150
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>