Artemide NUDA 50/100 Outdoor LED Floor Lamp Installation Guide
- June 9, 2024
- Artemide
Table of Contents
Artemide NUDA 50/100 Outdoor LED Floor Lamp
INSTALLATION INSTRUCTION
Prior to any work on the fixture always sWitch off the mains.ARTEMIDE S.p.a. does not shoulder any responsibilities for products which are modified Without prior authorisation. The light fitting requires a concrete base-plate A with draining well (fig. 1). Do not position the base-plate where water may stagnate. Cast concrete in the position selected and take care to leave the passage for routing the corrugated sheath B through the centre.
ASSEMBLY INSTRUCTIONS
Loosen the 4 screws C. Remove column D from light fitting mounting E (fig.2). Using mounting E as a template, mark positions for holes F (fig.3).
Use heavy-duty screw anchors (fig. 4). Cary out the wiring according to the polarity white/ white, black/ black and green/green creating a water-resistant connection. Fit the connection inside the draining well made earier. Put column D back into place. Screw in the 4 screws C (fig5)
LED REPLACEMENT
The fixture is provided with a light source having a long life. Anyway, if the
led needs to be replaced, this operation must be carried out only by our
specialized staff.
Therefore, we recommend contacting the nearest dealer. For the addresses of
Artemide dealers in the world, visit our website:
www.artemide.com.
Artemide reserves the right to introduce all the technical and structural changes required for the improvement of the product.
Warning: this equipment is guaranteed only when used as indicated in these instructions. Therefore they should be kept for future reference.
Artemide
Via Bergamo, 18
-20010 Pregnana M.se (MI) – ITALIA
t +39 02.935.18.1 f. +39 02.935.90.254-496
info@artemide.com
www.artemide.com
P. lva IT 00846890150
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>