Artemide Melampo Floor Lamp Installation Guide
- June 9, 2024
- Artemide
Table of Contents
Artemide Melampo Floor Lamp Installation Guide
Note:
Prior to any work on the fixture always disconnect the power.
ARTEMIDE spa not shoulder
any responsibilities should products be modified without prior authorisation.
Attention:
Only use bulbs of the type and wattage indicated on the rating plate.
Assembly instructions.
Tighten the bulbs. Insert the plug in the outlet. Turn the device ON and OFF by pressing the switch located on the power supply cable. The diffuser A can be set in the three positions shown in the figure by adjusting the lever B. Note: The device must not be used by placing the diffuser in a position different from those shown in the Figure.
Bulbs:
2 x MAX 75W IAA/W E27 opaline
Bulb for USA:
MAX 2 x 75W E26 opaline
General warnings for indoor light fittings.
The symbol indicates the suitabily of fixtures to be mounted directly on normally inflammable surfaces. Fixtures without the above symbol are only suitable for installation on non- inflammable surfaces.
AllARTEMIDE products falling within the range of application of the European low voltage directive B.T. 73/23 and subsequent amendment 93/68, meet the required specifications and bear ” labelling.
Artemide reserves the right to introduce all the technical and structural changes required for the improvement of the product.
Attention: This equipment is guaranteed only when used as indicated in these instructions. Therefore they should be kept for future reference.
In case of complaint, please quote number
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>