Artemide Tolomeo Classic LED Clip Spot Light Installation Guide
- June 9, 2024
- Artemide
Table of Contents
Tolomeo Classic LED Clip Spot Light
Installation Guide
Tolomeo Classic LED Clip Spot Light
Note:
Prior to any work on the fixture always switch off the mains.
Attention:
Only use bulbs of the type and wattage indicated on the rating plate.
ClassIIfixtures(markedbythe symbol 
) must be installed so that the
exposed metal parts do not come into electrical contact with parts of wiring
systems connected to a protective lead.
TOLOMEO CLAMP (fig. 1) Assembly instructions.
Unpack lamp. Press gently pliers and position lamp where you like. Insert
bulb. TOLOMEO WALL (fig. 2)
Assembly instructions. Unpack lamp. Attach earthing cable to screw B and
connect cables to terminalstrids A. Attach lamp to wall by means of holes C.
Insert bulb.
Note:
Prior to any work on the fixture always switch off the mains.
Only for
**USA- -CANADA
**
TOLOMEO WALL (fig. 3)
Mounting on wall.
Unpack lamp. Untighten screw D and eliminate earthing cable. Attach lamp to
wall by means of the two holes E; Attention: in this case, the canopy supplied
has not to be used. Insert bulb. Insert plug in the socket.
Mounting on wall box.
Cut feeding cable keeping a length of about20cmfrombottomplateoutput. Unthread
cable from fairlead F and remove sheath from the last part of it. Eliminate
fairlead F and insert cap G supplied. Make the three electrical cables pass
through canopy central hole. Make the electrical connections by connecting the
WHITE wire from the fixture to the WHITE wire from the wall box and the
fixture BLACK wire to the BLACK wire. Also connect the GREEN wire from plate
to the system ground conductor. Fix rose to wall box by means of suitable
canopy. Insert bulb.
General warnings for indoor light fittings.
The symbol indicates the suitabily of fixtures to be mounted directly on
normaly inflammable surfaces. Fixtures without the above symbol are only
suitable for installation on non- -inflammable surfaces.
All ARTEMIDE products falling within the range of application of the
European low voltage directive B.T. 73/23 and subsequent amendment 93/68, meet
the required specifications and bear ” ” labelling.
Artemide reserves the right to introduce all the technical and structural
changes required for the improvement of the product.
Attention: This equipment is guaranteed only when used as indicated in
these instructions. Therefore they should be kept for future reference.
In case of complaint, please quote number
via Bergamo, 18- -20010 Pregnana Milanese (Milano)- -ITALIA.
tel:93.51.81- -(a ricerca automatica) indirizzo telegrafico Artemide Pregnana
telex 332507 Artemi I- -telefax 02/93.59.02.54- -93.59.04.96 codice fiscale e
partita I.V.A. 00846890150
Bulb:
Max 1x100W E26
incandescent.