Artemide Tizio MICRO Table Lamp Installation Guide
- June 9, 2024
- Artemide
Table of Contents
TIZIO MICRO
Patent pending design : Richard Sapper
Apparecchio in classe II IP20 
Tizio MICRO Table Lamp
Note:
Prior to any work on the Trailways disconnect the power.
Caution:
Only use lamp softhearted indicated on the tinplate.
ARTEMIS spa ARTEMIS does not accept any responsibilities should products be
modification prior authorization.
BULB REPLACEMENT
Pull the spring A and remove from its housing.
Remove the glass B and replace the lamp C. Replacement
a similar one (base: G 4 frosted)press —fit it in the socket and make sure
that it is properly placed.
Do not touch the lamp glass with your bare hands. Should this happen, clean it
with some alcohol Reposition the cover glass B,insert the spring in the proper
sea and push gently until it is fixed Attention: during this operation, check
that the chamber of the cover glass B is positioned on the front side of the
head and turned outwards.
Press the red switch button to turn it on or adjust the light intensity.
Bulb:
20W 12V HSG G 4 halogen bi- -pin frosted
Use low pressure lamps only
General warnings for indoor light fittings.
The symbol indicates the suitably of fixtures to be mounted directly on normal
inflammable surfaces. Fixtures without the above symbol are only suitable for
installation on non- -inflammable surfaces.
All ARTEMIDE products fall within the range of application of the
European electromagnetic compatibility E.M.C. directive 89/336 and subsequent
amendment 92/31 and 93/68, and/or the European low voltage directive B.T.
73/23 and subsequent amendment 93/68, meet the required specifications and
bear ” ****” labelling.
The number enclosed within the symbol indicates the minimum distance in metres
to which the objects to be illuminated should be placed.
The distance is measured on the axis of vision of the fixture from the fixture
side or from the lamp nearer to the illuminated object.
For the replacement of the power supply cable, please contact ARTEMIDE service
centre.
Artemide reserves the right to introduce all the technical and structural
changes required for the improvement of the product.
Attention: This equipment is guaranteed only when used as indicated in
these instructions. Therefore they should be kept for future reference.
In case of complaint, please quote number Cod Y503000637
via Bergamo, 18- -20010 Pregnana Milanese (Milano)- -ITALIA
tel:93.51.81- -(a ricerca automatica)
telefax 02/93.59.02.54- -93.59.04.96 **
sito internet http://www.ARTEMIDE.COM**
codice fiscale e partita I.V.A. 00846890150
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>