Trust ACDB-8000A Multi Language Transmitter User Manual

: June 9, 2024
: Trust

Table of Contents

Trust ACDB-8000A Multi Language Transmitter
PUSH BUTTON FOR WIRELESS DOORBELL
Safety Instructions
Declaration of Conformity
TECHNICAL SPECIFICATIONS Push button
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Trust ACDB-8000A Multi Language Transmitter

START-LINE TRANSMITTER ACDB-8000A
USER MANUAL MULTI LANGUAGE

Item 71272/71276 Version 1.0 Always read the instructions before using this product

PUSH BUTTON FOR WIRELESS DOORBELL

ACDB-8000A PUSH BUTTON FOR WIRELESS DOORBELL Trust-ACDB-8000A-Multi-Language-
Transmitter-FIG-1

Remove battery strip before use

A Insert a flat head screwdriver into the notch on the bottom of the push button and slide the push button off the back plate
B Open the waterproof rubber by flipping it open to show the battery
C Remove the plastic battery strip.
D Close the waterproof rubber and place the push button back on the back plate.

Pair push button with a receiver

While the receiver is in learn mode, send an ON signal to pair the push button with the receiver.
Refer to manual of the receiver to activate the learn mode.

3A. Mount the push button with double-sided tape
Determine where the push button should be placed.
Stick the supplied double-sided tape on the back and attach the push button.

3B. Mount the push button with screws

A Insert a flat head screwdriver into the notch on the bottom of the push button and slide the push button off the back plate
B Determine where the push button should be placed and mount the back plate with the supplied screws.
C Place the push button back on the back plate by sliding it from top to bottom on the back plate

Replace the battery
When the battery is almost empty, the LED will light up for 2 seconds and then flash 3x after pressing the push button.

A Insert a flat head screwdriver into the notch on the bottom of the push button and slide the push button off the back plate
B Open the waterproof rubber by flipping it open to show the battery
C Take out the old battery and insert a new CR2032 battery. Note that the + side points upwards.
D Close the waterproof rubber and place the push button back on the back plate.

Combining Push Button with the Internet Control Station (ICS-2000) or Smart Bridge

Combine the push button with the Internet Control Station (ICS-2000) or Smart Bridge and receive a push notification on your smartphone when the doorbell rings. For example, this way you can easily create a silent doorbell.

Safety Instructions

Product support: www.trust.com/71272. Warranty conditions: www.trust.com/warranty
To ensure safe handling of the device, follow the safety advice on: www.trust.com/safety
The Wireless range is strongly dependent on local conditions such as the presence of HR glass and reinforced concrete
Never use Trust Smart Home products for life-support systems. This product is water-resistant. Do not attempt to repair this product. Wire colors may vary per country. Contact an electrician when in doubt about wiring. Never connect lights or equipment that exceed the maximum load of the receiver. Exercise caution when installing a receiver voltage may bepresent, even when a receiver is switched off. Maximum radio transmit power: 7.21 dBm. Radio transmission frequency range: 433,92 MHz

Disposal of packaging materials – Dispose of packaging materials which are no longer needed in accordance with applicable local regulations.
Disposal of the device – The adjacent symbol of a crossed-out wheelie bin means that this device is subject to Directive 2012/19/EU.
Disposal of batteries – Used batteries may not be disposed of in household waste. Only dispose of batteries when they are fully discharged. Dispose of batteries according to local regulations.
Trust Electronics Ltd. declares that item number 71272/71272-02/71276/71276-02 is in compliance with Directive
Electromagnetic Compatibility Regulations 2016, Radio Equipment Regulations 2017. The full text of the declaration of conformity is available at the following internet address: www.trust.com/compliance
Trust International B.V. declares that item number 71272/71272-02/71276/71276-02 is in compliance with Directive 2014/53/EU – 2011/65/EU. The full text of the EU declaration of conformity is available at the following web address: www.trust.com/compliance

Declaration of Conformity

Trust International B.V. declares that this Trust Smart Home-product:
Model: ACDB-8000A PUSH BUTTON FOR WIRELESS DOORBELL
Item number: 71272/71272-02/71276/71276-02
Intended use: Outdoor
is in compliance with the essential requirements and other relevant provisions of the following directives:

ROHS 2 Directive (2011/65/EU)
RED Directive (2014/53/EU)

The full text of the EU declaration of conformity is available at the following web address: www.trust.com/compliance
TRUST SMART HOME
LAAN VAN BARCELONA 600
3317DD DORDRECHT
NEDERLAND www.trust.com