ARMANDO VICARIO 700007 Provincial Floor Mounted Bath Filler Instruction Manual
- June 9, 2024
- ARMANDO VICARIO
Table of Contents
VICARIO 700007 Provincial Floor Mounted Bath Filler
Instruction Manual
700007 Provincial Floor Mounted Bath Filler
NOTE: BEFORE STARTING SHUT OFF YOUR WATER HEATING SYSTEM AND CLOSE THE MAIN
STOP COCK. ATTENTION
Before installing the mixer it is essential that you thoroughly flush through
the supply pipes in order to remove any remaining swarf, solder or other
impurities. Failure to carry out this simple procedure could cause problems or
damage to the workings of the mixer.
-
Screw the “S” wall unions into the main G1/2 pipes. Use idraulic tape to get a seal connection. Screw the wall flanges.
-
Rotate the “S” unions in order to obtain a distance between them of 150mm. Secure mixer into position by turning back-nuts. Do not forget the washers.
-
Mount the shower support as shown in the figure.
Note: to avoid mistake in finding the correct position use the flexible. -
Connect the flexible between the mixer and the shower. Do not forget the washers in both the connections.
-
After installing the mixer unscrew the aerator and open both the waters in order to remove any working impurities.
Dimensions
Installation shall be in accordance with the AS/NZ3500 series of Standards.