havit HV3641T-BLK-240V Lisse + Essil Wall Light Instruction Manual
- June 4, 2024
- havit
Table of Contents
Instruction Manual
HV3641T-BLK-240V Lisse + Essil Wall Light
Lisse + Essil Wall Light Installation Instructions
Product Specifications
Model No.| HV3641T-BLK-240V| HV3641T-WHT-240V| HV3645T-BLK-240V| HV3645T-WHT-
240V| HV3641T-BLK-12V| HV3641T-WHT-12V| HV3645T-BLK-12V| HV3645T-WHT-12V
Name| Lisse| Essie| Lisse| Essie
Material| Aluminum
Colour| Black| White| Black| White| Black| White| Black| White
IP Rating| IP54| IP54
Protection Class| 1 (240v Requires Earth)| 3 (Low Voltage)
Input Voltage| 240v AC| 240v AC
Lamp Base| Built-in LED| Built-in LED
Lamp Wattage| 2x 3w| 2x 4.5w
Colour Temp| | TRI Colour – 3000k, 4000k, 5500k
Lumens| 240lm, 250lm, 260lm| 2x 200lm| 2x 210lm| 2x 200lm| 2x 300lm, 2x 310lm,
x 320lm
CRI| > 80| > 80
Wiring| Parallel| Parallel
Dimmable| No| No
Warranty| 3 Years Replacement| 3 Years Replacement
Important Safety Issues:
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Modification of this product will void any warranty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- Aluminum and 304SS fittings must not be installed within 5km of any saltwater environments.
- All o-rings and seals must be in place correctly to maintain a warranty
- This form may be updated at any time due to product improvements, please check the online installation form for the most current version.
Steps for Installation:
-
Make sure that the electrical circuit is free of voltage (master switch off)
-
Loosen Allen screws from the side of the fitting.
-
Remove the base plate from fitting.
-
Install base plate to the wall in the desired location using appropriate screws for application.
-
Seal all holes including cable entry and around screws
-
240v Models
• – Use wire with earth; connect the earth first, then live and a neutral wire. -
12v DC Models, Use an appropriate 12v DC LED Driver – DO NOT CONNECT LIGHT FITTING DIRECTLY TO 240V –
• Connect Live and then neutral. -
Fitting is preset to 3000k, to change the slide switch located inside the base of fitting to desired color temperature.
-
Reattach fitting to base plate making sure screws are tight to avoid any water penetration.
-
Apply silicon around the edge of the fitting to prevent any water from getting inside to electrical connections.
-
All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Must be installed by a licensed electrician
Contact Details:
143 Beauchamp Road
Matraville NSW 2036
Australia| Tel: 02 9381 8300
Fax: 02 9666 8881
Email: sales@havit.com.au
Web: www.havit.com.au
| **Warranty Terms & Conditions*** | Additional Information |
|---|---|
| https://havit.com.au/pages/warranty-terms-and-conditions |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>