Fenix T6 Automatic Contract Contractive Tactical Pen User Guide

T6
AUTOMATC CONTRACTIVE TACTICAL PEN
User Guide

T6 Automatic Contract Contractive Tactical Pen

| 80 LUMENS MAXIMUM OUTPUT
---|---
| 26 HOURS MAXIMUM RUNTIME

WARNING

• Do place this tactical pen out of the reach of children!
• Do NOT shine the tactical penlight directly into the eyes of anyone!
• Do NOT shine flammable objects at close range, to avoid burning objects or causing danger due to high temperature!
• Do NOT use the tactical penlight in inappropriate ways such as biting in the mouth, to avoid personal injury or life threats when the tactical penlight or internal battery fails! This tactical penlight will accumulate a lot of heat while working, resulting in a high temperature of the tactical penlight shell. Pay attention to safe use to avoid scalding.
• Turn off and lock the tactical penlight or remove the battery from the tactical penlight to prevent accidental activation when the tactical penlight is placed in a closed and flammable environment such as pockets and backpacks!
• The LED of this tactical penlight is not replaceable; so the whole tactical penlight should be replaced when the LED reaches the end of its life.

FENIX T6 TACTICAL PENLIGHT

• 80 lumens maximum output and 18 meters maximum beam distance.
• Uses a quality LED with a lifespan of 50,000 hours.
• Built-in 100mAh Li-Polymer battery.
• USB Type-C charging port.
• Removable Schmidt 6.8CM metal pen refill for self-defense.
• Automatic contractive pen for smooth writing.
• Ceramic bead for glass breaking.
• Made of A6061-T6 aluminum.
• Premium type HAIII hard-anodized anti-abrasive finish.
• Size: 5.51″ x 0.55″ x 0.55″/ 140 x 14 x 14 mm.
• Weight: 1.16 oz / 33g (including battery).

OPERATING INSTRUCTION

On/off
Press and hold the switch for 0.5 seconds to turn on/off the penlight.
Output Selection
With the penlight switched on, single click the switch to cycle through Low→Med→High.
Lock/Unlock

TECHNICAL PARAMETERS

Note: According to the ANSI/PLATO FL1 standard, the above specifications are 100mAh Li-Polymer battery under the temperature of 21±3°C and humidity of working environments and the battery status.
*The High mode is measured in a total of runtime including output at reduced tom the results produced by Fenix through its laboratory testing using the built-in 0% – 80%. The true performance of this product may vary according to different Is due to temperature or protection mechanism in the design.

Lock: with the tactical penlight unlocked and switched off, double click the switch within 0.5 seconds to lock the penlight, the penlight will blink twice on Low to indicate locked status. Unlock: with the penlight locked, double click the switch within 0.5 seconds, the penlight will be unlocked and activated on Low. *In locked status, clicking or pressing the switch will activate 2 one-second blinks on Low to indicate locked status.

CHARGING

1. First loosen the penlight body to reveal the USB Type-C charging port and plug the USB A socket of the charging cable into an electrical outlet, then connect the USB Type-C socket of the charging cable to the penlight.
2. The indicator will display red while charging and will turn green when fully charged.
3. Once charging is completed, be sure to tighten the penlight head to maintain the dustproof and waterproof ability.

Note:

1. Charge the penlight timely when the battery power gets too low to ensure the normal life of the battery.
2. The normal charging time is approximately 1 hour and 20 minutes from depletion to full charging.
3.  Recharge a stored penlight every four months to maintain the optimum performance of the battery.

BATTERY LEVEL INDICATION

Each time the tactical penlight is turned on, the indicator will indicate the battery level and will last for 3 seconds. Green light on: saturated 100% – 85% Green light flashes: sufficient 85% – 50% Red light on: poor 50% – 25% Red light flashes: critical 25% – 1%

INTELLIGENT OVERHEAT PROTECTION

The penlight will accumulate a lot of heat when used on High mode for extended periods. When the penlight reaches a temperature of 60°C or above, the penlight will automatically step down a few lumens to reduce the temperature. When the temperature drops below 60°C, it will then allow the user the reselection of High mode.

LOW-VOLTAGE WARNING

When the voltage level drops below the preset level, the penlight is programmed to downshift to a lower brightness level until the Low mode is reached. When this happens in Low mode, the battery level indicator constantly blinks red to remind you to timely recharge the battery.

USAGE AND MAINTENANCE

• Disassembling the sealed head can cause damage to the penlight and will void the warranty.
• Lock the penlight to prevent accidental activation during storage or transportation.
• Long-term use can result in 0-ring wear. To maintain a proper water seal, replace the ring with an approved spare.
• Timely close the pen when it is not in use to avoid ink pollution.

INCLUDED

Fenix T6 Tactical Pen (including Schmidt 6.8CM metal pen refill), USB Type-C charging cable, Spare 0-ring, User manual, Warranty card

LIGHTING FOR EXTREMES

http://weixin.qq.com/r/83U_JiHEP3xArWVF9yDh

“Follow” us for more information about Fenix.

FENIXLIGHT LIMITED
Tel: +86-755-29631163/83/93
Fax: +86-755-29631181
E-mail. info@fenixlight.com
Web: www.fenixlight.com
Address: 2F/3F, West of Building A, Xinghong Technology Park, 111 Shuiku Road, Fenghuanggang Community, Xixiang Street, Bao’an District, Shenzhen City, Guangdong Province, China
61.149.221.051-A2-20220916

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>