Shark NVC80C Series Upright Vacuums FAQs
- June 9, 2024
- Shark
Table of Contents
Shark NVC80C Series Upright Vacuums FAQs
FAQs
HOW DO I TEST SUCTION OR LOOK FOR CLOGS?
EMPTY and take off your dustcup. Remove the filters from underneath. There
should be one thick foam one and a thin felt one. Careful, they will be dirty.
Now, put your dust-container back on and – In back of the machine – remove the
hose from the plastic elbow (Page 5 – Illustration 9A). Turn on machine and
cover the elbow with you hand. If the suction on your hand is strong, turn off
machine and put the hose back on. Remove the other hend of the hose from the
cleaning wand (Page 5 – Illustration 9D) and test suction level on your hand
again with that end of the hose. This can also be done at the end of the
c;eaning wand and by detaching the short hose at the bottom from the floor
nozzle. The blockage(s) will be found just before where the suction against
your hand is reduced.
WHAT IS THE SLIDER BUTTON ON THE CLEANING TUBE FOR?
That is the suction control. By sliding that button and exposing the air flow,
the suction is reduced enough so that you can use your machine on upholstery
or drapery without fear of clogs. When finished, simply slide shut and you
will have maximum suction again
HOW OFTEN SHOULD I CLEAN THE FILTERS?
For the foam and felt filters, they should be rinsed in lukewarm water
once-a-month (perhaps more often for pet owners). The HEPA filter over the
exhaust need only be done once every year or two.
ARE THESE LIFTETIME FILTERS FOR FREE?
The filters are warrantied for life. That is to say that so long as your rinse
them once-a-month, you should never need to replace them. Extra (XF22) will
only be needed if you wish to have spares while your originals are air drying.
HOW DO I CLEAN THE FILTERS?
Simply rinse them under lukewarm tap-water and allow them to air dry for at
least 24 hours. Do NOT use wet filters as any dust which hits a wet filter can
turn to clay and destroy your machine.
HOW MUCH ARE THE BELTS? HOW DO I REACH THE BELTS?
The belts on your NVC80C floor brush are warrantied for the life of the
machine. You will never need to replace them. If anything gets inside the
floor nozzle and stops it from turning, the floor nozzle will turn off. You
need only turn off and unplug the machine the machine and then locate and
remove the item wedged into the brush roll. You cannot reach the belts and
will not need to.
HOW LONG IS THE PLUG ON MY NVC80C?
30 feet
WHY DOES THE NOZZLE TUBE HAVE A HOLE IN IT?
Yes, this hole is intended to be there. There is nothing wrong with the unit.
It is designed to prevent difficult push/pull and not allow debris to affect
the nozzle.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>