Ledkia IE COB Strip 5m IP20 COB Strip Light With RF Mini Controller User Manual

June 9, 2024
Ledkia IE

Ledkia IE COB Strip 5m IP20 COB Strip Light With RF Mini Controller

Ledkia-IE-COB-Strip-5m-IP20-COB-Strip-Light-With-RF-Mini-Controller-
fig-1

Packing list

Ledkia-IE-COB-Strip-5m-IP20-COB-Strip-Light-With-RF-Mini-Controller-
fig-2

  • UL listed Plug-in 36Wadapterx 1
  • RF controller with 11 key remote x 1
  • 5m 336Chip COB LED strip x 1
  • User Manual x 1

Specifications

  • Length: 16.4ttl5ml
  • Rated PowerlLED Strip]: 24V/30W
  • Chips: 336Pcs/m, W/R/G/B/Y
  • Cutting Unit: Every 1.41inl35.71mm]
  • Dimmer: Mini Controller
  • Adapter: AC100-240V, 50-60Hz
  • Rated Power!Adapter]: 24V1 .5A/36W

Wiring

Ledkia-IE-COB-Strip-5m-IP20-COB-Strip-Light-With-RF-Mini-Controller-
fig-3

Installation

Ledkia-IE-COB-Strip-5m-IP20-COB-Strip-Light-With-RF-Mini-Controller-
fig-4 Ledkia-IE-COB-Strip-
5m-IP20-COB-Strip-Light-With-RF-Mini-Controller-fig-5

Instructions

  1. Open the package and check if all the components are complete, then unrolling the led strip, and connect the COB strip to controller and driver and light it up to check if all parts are in good condition or not, The connect method should refer to the wiring diagram.
  2. Clean the surface on the installation surface, make sure it’s clean, dry and smooth, Or it will reduce the adhesiveness of the back tape. Remember the back tape could be only used one time. The COB strip will fall off if the surface is not in good condition or the back tape is reused.
  3. Measure the length required on the surface and cut the COB strip accordingly.
  4. Tear off the back tape and paste the strip to the surface smoothly and correctly. Connect the COB strip to controller and driver based on the diagram.
  5. Fix the driver, make sure all the components are tightly and not fall off.

Warning

  1. Do not use at outdoor or underwater.
  2. Disconnect the power before installation.
  3. The operating temperature is – 10°C to + 40°C, please make sure the installation surface should be less than 40°C.
  4. Do not use the products close to flammable materials.
  5. The 36W adapter only for 16.4ft[5m) COB strip, do not afford to Another COB strip or it would be overload.
  6. Do not power the COB strip while it’s rolled, or it will be overheat and damaged.
  7. Do not power the COB strip by other power source, like 120VAC or 120VDC, the electronic components will be damaged.
  8. Keep the components from children.

Customer Service

We are looking forward to provide best products and service for you, and paying attention to your feedback.

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals