AMBIENTEDIRECT Waxed Wood Tage Zians Large Double Bed User Manual
- June 9, 2024
- AMBIENTEDIRECT
Table of Contents
Waxed Wood Tage Zians Large Double Bed
User Manual
OUT
OBJEKTE UNSERER TAGE
CARE & MAINTENANCE
Waxed wood
Waxed Wood Tage Zians Large Double Bed
Do you need help?
info@out-design.com
+49 30 44 67 38 00
IMPORTANT INFORMATION: The instructions for care and cleaning are only
indicative. OBJEKTE UNSERER TAGE disclaims any liability in relation to the
use of the following care and cleaning instructions. Any use is at all times
at the customer‘s own responsibility.
SOLID WOOD OF THE HIGHEST QUALITY
Only precious woods from sustainable forestry in the highest quality grade according to DIN standard are selected for the solid wood tables from OUT. The quality of the surface is characterized by a calm sorting and has neither indentations nor unevenness. The closed surface offers the best conditions for high-quality solid wood tables. Within this standard, there is a wide range of possible grain patterns, making each table a living unique specimen. Unlike veneer, which looks artificial and dead in comparison. In addition, veneer does not offer the pleasant feel and cannot be repaired.
WAXED SURFACE
Finishing with wax is a particularly sustainable and long-lasting choice that
offers many advantages over lacquering. The OUT solid wood tables are waxed
twice during production and are characterised by a homogeneous and ultra-matt
finish.
It is necessary to maintain the surface, but this is very uncomplicated and
simple. The table surface should be waxed after receipt and then as needed 2
to 3 times a year. This is because the wax soaks into the solid wood and
evaporates over time. It is possible that the table will feel more velvety in
some places and a little rougher in others. This effect is quite natural and
is related to the grain. With a so-called horizontal grain or vertical grain,
the wax is absorbed differently in each case. This characteristic of the
natural material is not unusual and can be haptically compensated for by care.
By the way, during the re-waxing process, stains and small defects can easily
be repaired and removed. Through appropriate care, as described here, the
table becomes extremely robust and extremely durable.
Precious woods are natural products that are visually and haptically very
complex, which is what makes a solid wood table from OUT so attractive in the
first place.
INDOOR CLIMATE
The care of wood begins with the right room climate. This applies to both
waxed and lacquered surface finishes. Especially extreme fluctuations in
humidity and temperature, but also a permanently unfavourable room temperature
or very dry heating air, pose a challenge. Solid wood should not be exposed to
these. This is because the wood reacts to these influences with shrinkage and
swelling, which can lead to warping, shrinkage and fine hairline cracks.
A solid wood table should accordingly not be placed near a fireplace or a
heater to avoid too rapid and drastic fluctuations. Laundry should also not be
dried in the same room. A relative humidity of 45 % to 60 % is recommended,
which is also ideal for humans. The optimal living room temperature for wood
is between 20° and 24 °C. In almost all cases, stress cracks are due to
„extreme“ climatic conditions. Therefore, the indoor climate, especially
humidity and temperature, should be checked regularly. Fine cracks can close
again on their own with a waxed surface, as the wood regains an optimal wood
moisture content through continuous and appropriate air humidity. In the case
of the MEYER table, the degree rails (in the transverse direction) on the
underside of the tabletop can also be loosened slightly by loosening the
screws a little. This gives the table a little more freedom to react and
relieve the tension.
DAILY CLEANING
Wooden tables can be wiped with a clean, dry cloth. Dust-binding sprays or
impregnated cloths should not be used. For damp cleaning, a solution of
lukewarm water and a mild detergent is recommended. A soft cloth is also used
for this purpose. Microfibre or leather cloths give very good results.
Cleaning should not be too wet, the cloth used should only be damp. The use of
aggressive cleaning agents or abrasive aids should always be avoided.
Water and soap residues are then dried with a dry cloth. Treatments of the
wood should always be carried out in the direction of the fibres. It is
possible that the wood fibres stand up due to damp cleaning. This can make the
surface feel rougher in places. This effect can be remedied with a very fine
sandpaper (grain size 220 – 400). Again, it is important to always work in the
direction of the grain. Direct re-waxing is not necessary. Stains or spilled
liquids should be removed immediately. This will prevent permanent damage. Hot
objects such as pots should not be placed directly on the wood surface to
avoid heat stains. Exposing wooden furniture to strong, direct sunlight should
be avoided.
DESIGNED IN BERLIN
MADE IN GERMANY
Documents / Resources
|
AMBIENTEDIRECT Waxed Wood Tage Zians Large Double
Bed
[pdf] User Manual
Waxed Wood, Tage Zians Large Double Bed, Large Double Bed, Tage Zians Double
Bed, Double Bed, Bed
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>