VMP ER-148-4PKIT 2-Post Expansion Kit Instruction Manual
- June 9, 2024
- VMP
Table of Contents
VMP ER-148-4PKIT 2-Post Expansion Kit
PARTS
Step 1
Before starting lay out all parts to your mount and match them to the parts
list provided. Verify that you have all your parts before attempting to
assemble the mount. Also before attempting to assemble the ER-148-4PKIT you
should have already assembled the ER-148.
Note: ER-148-4PKIT part numbers are in circles and ER-148 part numbers are in triangles.
Step 2
Remove the ¼” – 20UNC screws ER-148 and nuts ER-148 from the Support Plate
ER-148.
Step 3
Attach the two Connector Plates ER-148-4PKIT to the Support Plate ER-148-4PKIT
using the ¼” – 20UNC screws ER-148-4PKIT and nuts ER-148-4PKIT.
Step 4
Attach the other end of the Connector Plate ER-148-4PKIT to the Support Plate
( ER-148 using the screws ( ER-148 and nuts ( ER-148 removed in step 2.
Step 5
Attach the Left Support “L” ( ER-148-4PKIT and Right Support “L” (
ER-148-4PKIT to the Support Plate ( ER-148-4PKIT and Base ( ER-148 using the
¼” -20UNC screws ( ER-148-4PKIT and nuts ( ER-148-4PKIT. Note: It is easier to
attach the “L” Supports if you have all the screws lightly secured until all
screws are in place and then tighten them down.
Enjoy Your Mount
WARNING: The installer of these products must verify that the mount surface, ceiling or wall, will safely support the combined weight of all attached equipment and hardware. Video Mount Products will not be held liable for the improper use or installation of its products.
For more information, please contact us at: 345 Log Canoe Circle, Stevensville, Maryland 21666 Toll Free: 877.281.2169 Phone: 410.643.6390 Fax: 410.643.6615 www.videomount.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>