NAVAC NTBRK Reverse Bending Attachment Kit Installation Guide
- June 9, 2024
- NAVAC
Table of Contents
NAVAC NTBRK Reverse Bending Attachment Kit
How To Install Reverse Bender
- Lock ( d ) Reverse Bend Retaining Block using ( g )Screw A onto tube bender, press appropriately sized ( b ) Mandrel into the ( d ) Reverse Bend Retaining Block, with angle marks side facing down.
- Lock ©Crossbar onto ( a )Reverse Bend Top Block, then insert it into the ( e )Pushing Head and lock it with ( f ) Screw B.
- Slide ( h ) Tubing Size Selectors into the right position. Both ( h ) Tubing Size Selectors should have the proper-sized notches facing the ( b ) Mandrel. Place the copper
tube into the notches. Push the control button to start bending.
Not sure hOIN to install?
Scan to watch video instructions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>