hama 00186336 Radio-Controlled DCF Wall Clock Instruction Manual

hama 00186336 Radio-Controlled DCF Wall Clock

Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.

Explanation of Warning Symbols and Notes

Warning

This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.

Note

This symbol is used to indicate additional information or important notes.

Package Contents

• PG-300 DCF wireless wall clock
• 1 (AA) battery
• These operating instructions

Safety Notes

• Protect the product from dirt, moisture and overheating, and only use it in a dry environment.
• Do not use the product in areas where the use of electronic devices is not permitted.
• Do not drop the product and do not expose it to any major shocks.
• Do not put the product near interference fields, metal frames, computers, TVs, etc. Electronic devices and window frames can negatively affect the product’s functionality.
• Do not modify the product in any way. Doing so voids the warranty. Keep the packaging material out of the reach of children due to the risk of suffocation.
• Dispose of packaging material immediately according to locally applicable regulations.
• The product is intended for private, non-commercial use only.
• Use the product for its intended purpose only.
• Do not use the product in the immediate vicinity of heaters or other heat sources or in direct sunlight.
• Do not operate the product outside the power limits given in the specifications.
• Do not open the device or continue to operate it if it becomes damaged.
• Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
• Keep this product, as all electrical products, out of the reach of children!
• Use the item only in moderate climatic conditions.

Warning – Batteries

• When inserting batteries, note the correct polarity (+ and -markings) and insert the batteries accordingly. Failure to do so could result in the batteries leaking or exploding.
• Only use batteries (or rechargeable batteries) that match the specified type.
• Before you insert the batteries, clean the battery contacts and the polar contacts.
• Do not allow children to change batteries without supervision.
• Do not mix old and new batteries or batteries of a different type or make.
• Remove the batteries from products that are not being used for an extended period (unless these are being kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a fire.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow them to enter the environment. They can contain toxic, environmentally harmful heavy metals.
• Immediately remove and dispose of dead batteries from the product.
• Avoid storing, charging or using the device in extreme temperatures and extremely low atmospheric pressure (for example, at high altitudes).

Getting Started

Inserting the battery

• Remove the battery that was already inserted into the clock, remove the protective film if necessary as well as the contact interrupter and the re-insert the battery with the correct polarity. The clock is ready for operation.

Replacing the battery

• Remove and dispose of any used batteries. Insert the new battery (AA). Ensure that the polarity of the battery corresponds to the symbols in the battery compartment.

Installation

You can mount the wall clock on a wall using the opening on the back.

Warning – Mounting Note:

• Before mounting the clock, ensure that the chosen wall is suitable for the weight to be mounted, and make sure that there are no electrical wires, water, gas or other lines at the installation site on the wall.
• Purchase special fastening materials from specialised dealers.
• Do not mount the product above locations where persons might linger.

Operation

Automatic time setting

• Once the battery is inserted properly, the clock will automatically
  be set to 12:00 and its reception will be activated. As soon as the DCF signal was received and processed (approx. 3 minutes up to a maximum of 15 minutes), the correct time is displayed automatically. Do not move the clock during this process.

• If the clock has not correctly set itself after 15 minutes, there is a problem with the reception or with the selected location.

• Repeat the setting process at another location. To do this, remove the battery for approximately 1 minute and then reinsert it into the battery compartment.

Setting the time manually

M.SET button:

• Hold down the M.SET button until the appropriate time appears.
• As soon as the clock receives the DCF signal, it will reset the time. REC button:
• Press and hold the REC button on the rear side for 3 seconds. The seconds hand moves to the 12 position. It then tries to receive the time signal and reset itself accordingly.
• If the clock finds a DCF signal, it adjusts itself automatically. If no signal is received within 16 minutes, the clock reverts to the original time.

RESET button:

• Press and hold the RESET button on the rear side for 3 seconds. The clock sets itself to position 12. It then tries to receive the time signal and reset itself accordingly.

Note

Note that electronic devices such as TVs, PCs, etc. can interfere with reception when located within up to two metres of the product.

Care and Maintenance

Only clean this product with a slightly moist, lint-free cloth, and do not use aggressive cleaning agents. Make sure that water does not get into the product.

Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

Technical Data

Declaration of Conformity

Hereby, Hama GmbH & Co KG declares that the radio equipment type [ 00186336, 00186337] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.hama.com -> 00186336, 00186337 -> Downloads.

• Frequency band(s) 77.5 kHz

Service & Support

www.hama.com
+49 9091 502-0

All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>