chauve Rogue Outcast 2 Beam User Guide

June 9, 2024
chauve

chauve Rogue Outcast 2 Beam User Guide
chauve Rogue Outcast 2 Beam

Safety Notes

These Safety Notes include important information about installation, use, and maintenance of the Rogue Outcast 2 Beam.

  • The luminaire is intended for professional use only.
  • The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than 34.4 ft (10.5 m) is not expected.
  • If the external flexible cable or cord of this luminaire is damaged, it shall be replaced by a special cord or cord exclusively available from the manufacturer or its service agent.
  • The light source contained in this luminaire shall only be replaced by the manufacturer or its service agent or a similar qualified person.

CAUTION:

  • This product’s housing may be hot when operating. Mount this product in a location with adequate ventilation, at least 20 in (50 cm) from adjacent surfaces.
  • When transferring the product from extreme temperature environments, (e.g., cold truck to warm humid ballroom) condensation may form on the internal electronics of the product. To avoid causing a failure, allow the product to fully acclimate to the surrounding environment before connecting it to power.
  • Flashing light is known to trigger epileptic seizures. User must comply with local laws regarding notification of strobe use.

ALWAYS:

  • Disconnect from power before cleaning the product or replacing the fuse.
  • Replace the fuse with the same type and rating.
  • Use a safety cable when mounting this product overhead.
  • Connect this product to a grounded and protected circuit.

DO NOT:

  • Open this product. It contains no user-serviceable parts.
  • Look at the light source when the product is on.
  • Leave any flammable material within 20 cm of this product while operating or connected to power.
  • Connect this product to a dimmer or rheostat.
  • Operate this product if the housing, lenses, or cables appear damaged.
  • Submerge this product (IP65). Regular outdoor operation is fine.
  • Permanently install outdoors in locations with extreme environmental conditions. This includes, but is not limited to:
    • Exposure to a marine/saline environment (within 3 miles of a saltwater body of water).
    • Locations where normal temperatures exceed the temperature ranges in this manual.
    • Locations that are prone to flooding or being buried in snow.
    • Other areas where the product will be subject to extreme radiation or caustic substances.
  • ONLY use the hanging/mounting bracket to carry this product.
  • The maximum ambient temperature is 113 °F (45 °C). Do not operate this product at higher temperatures.
  • The minimum startup temperature is -4°F (-20°C). Do not start the product at lower temperatures.
  • The minimum ambient temperature is -22°F (-30°C). Do not operate the product at lower temperatures.
  • To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely disconnect the product from power via breaker or by unplugging it.
  • In the event of a serious operating problem, stop using immediately.

What is Included

  • Rogue Outcast 2 Beam
  • Seetronic Powerkon IP65 power cord
  • 2 omega brackets with mounting hardware
  • Quick Reference Guide

Control Panel Description

Button Function
MENU Exits from the current menu or function
ENTER Enables the currently displayed menu or sets the currently

selected value into the selected function
UP| Navigates upwards through the menu list or increases the numeric value when in a function
DOWN| Navigates downwards through the menu list or decreases the numeric value when in a function

Scan the QR code to access the product page, warranty terms, and the complete User Manual.

Contact Us

General Information

Chauvet World Headquarters

Address: 3360 Davie Rd.
Voice: 844-393-7575
Davie, FL 33314 Fax: 954-756-8015
Voice: 954-577-4455
Email: chauvetcs@chauvetlighting.com
Fax: 954-929-5560
Toll Free: 800-762-1084
Website: www.chauvetprofessional.com

Chauvet U.K.

Address: Unit 1C
Email: UKtech@chauvetlighting.eu
Brookhill Road Industrial Estate
Pinxton, Nottingham, UK
Website: www.chauvetprofessional.eu
NG16 6NT
Voice: +44 (0) 1773 511115
Fax: +44 (0) 1773 511110

Chauvet Benelux

Address: Stokstraat 18 Email: BNLtech@chauvetlighting.eu
9770 Kruishoutem
Belgium Website: www.chauvetprofessional.eu
Voice: +32 9 388 93 97

Chauvet France

Address: 3, Rue Ampère
91380 Chilly-Mazarin
Email: FRtech@chauvetlighting.fr
France Website: www.chauvetprofessional.eu
Voice: +33 1 78 85 33 59

Chauvet Germany

Address: Bruno-Bürgel-Str. 11
28759 Bremen
Email: DEtech@chauvetlighting.de
Germany Website: www.chauvetprofessional.eu
Voice: +49 421 62 60 20

Chauvet Mexico

Address: Av. de las Partidas 34 – 3B
(Entrance by Calle 2)
Email: servicio@chauvet.com.mx
Zona Industrial Lerma
Website: www.chauvetprofessional.mx
Lerma, Edo. de México, CP 52000
Voice: +52 728-690-2010

Visit the applicable website above to verify our contact information and instructions to request support. Outside the U.S., U. K., Ireland, Mexico, France, Germany, or Benelux, contact the dealer of record.
Symbols

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals