VAN GUARD IN8101 Vauxhall Movano x4 ULTI Van Roof Bars Instruction Manual

VAN GUARD IN8101 Vauxhall Movano x4 ULTI Van Roof Bars

**Read instructions carefully before fitting and follow them for correct

use**

• Maximum load is in accordance with the vehicle manufacturer’s load bearing capacity (refer to the vehicle handbook). Do not exceed this limit.

THIS PRODUCT SUITS THE FOLLOWING VEHICLES

1. Loosely secure the middle inner fixing brackets to the inside of the vehicle by inserting the M6 1/4 turn nut inserts (FX4025) into the positions shown in FIG.1. Then place the middle inner bracket into place and loosely bolt into the M6 1/4 turn inserts using M6x20 hex bolts and M6 washers. Please note the cable trim (shown in FIG.2) may have to be removed. This trim can be refitted after the inner bracket has been secured.

2. Loosely secure the rear inner fixing brackets to the inside of the vehicle by inserting the M6 1/4 turn nut inserts (FX4025) into the positions shown below. Then place the rear inner bracket in position and loosely bolt into the M6 1/4 turn inserts using M6x20 hex bolts and M6 washers.

3. Loosely secure the front inner fixing brackets to the inside of the vehicle. Where a sliding door is present remove the 2X star drive screws, place front inner bracket in position and refit star drive screws as shown in fig.1. (Do not remove door rail bracket) Where a sliding door is not present insert the M6 1/4 turn nut inserts into the positions shown in fig.2. Then place the front inner bracket in position and loosely bolt into the M6 1/4 turn nut inserts using M6x20 hex bolts and M6 washers.

4. Place the roof brackets onto the roof and bolt down through the fixing points and through the inner fixing brackets using M8X40 hex bolts, M8 washers & rubber washers.

5. Place the roof bars onto the roof brackets and loosely secure using M6X16 coach bolts & M6 flange nuts.

6. Adjust the roof bars to ensure that they are evenly spaced on the vehicle.

7. Tighten the roof bar fixings to 8Nm.

8. Secure the roof brackets to the inner fixing brackets using M8 flange nuts and tighten to 12Nm.

9. Tighten the M6 fixings on all inner fixing brackets to 8Nm.

10. Regularly inspect all fixings and parts. Any damaged or worn parts should be immedi-ately removed from the vehicle and replaced.

11. Take care when loading and unloading goods on to and off the vehicles roof.

12. Van Guard Accessories LTD and/ or its distributors do not accept liability for:

    • Any products that have been fitted incorrectly.
    • Any products which have been fitted to the incorrect vehicle.
    • Any products that have been modified in any way or are being used for any purpose that they are unintended for.

13. It is important that the end user receives this document and that instructions are retained for future use.

References

• Van Roof Racks | Van Racking | Van Accessories - Van Guard Accessories

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>