SEVILLE CLASSIC OFF65800 AIRLIFT XL Sit-Stand Mobile Desk User Manual

: June 4, 2024
: SEVILLE CLASSIC

Table of Contents

SEVILLE CLASSIC OFF65800 AIRLIFT XL Sit-Stand Mobile Desk
Parts List
Assembly
Use Instructions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SEVILLE CLASSIC OFF65800 AIRLIFT XL Sit-Stand Mobile Desk

Thank you for choosing Seville Classics! We hope that you enjoy your new sit- stand desk. Please read through this user guide for parts list, assembly instructions, frequently asked questions and further contact information.

Parts List

Top
Cylinder
Adjustment Lever
Base
Caster (2)
Locking Caster (2)
Screws (10)
Washer (4
Crush washer (4)
Wrench
Allen key

Please make sure you have all the parts on this list.
If you’re missing parts, contact us for replacements at 800-323-5565 or send an email to Support@SevilleClassics.com

Assembly

Step 1. Attach Cylinder to Top Tool required: Allen key (K) Place the top of the desk (A) face down so the mounting plate faces up. CAUTION: Place a blanket between the top and hard floors to avoid scratches. Line up the holes on the cylinder (B) with holes on the mounting plate. Loosely secure cylinder with four screws (G) and Allen key.
IMPORTANT: Make sure adjustment lever (C) can reach the mounting holes on the back of the top (A).
Step 2. Install Adjustment Wire Press the adjustment wire into the bracket on the back side adjustment lever (C).
Important: Lever will not work and height will not adjust if wire is not clipped in correctly.
Step 3. Install Adjustment Paddle Tool required: Allen key (K) Line up the holes of the adjustment lever (C) with the holes on the back of the desk. Loosely secure adjustment lever with three screws (G) and Allen key (K).
Step 4. Attach Base to Cylinder Tool required: Allen key (K) Turn the base (D) upside down and fit it to the small end of the cylinder (B). Match the three holes on the bottom of the base with the three holes in the cylinder. Loosely secure the base (D) to the cylinder (B) with three screws (G) using the Allen key (K).
Step 5. Install Casters Tools required: Wrench (J) Install locking casters (F) on the long legs of thebase and normal casters (E) on the short legs of thebase. Screw the casters in by hand through a crush washer (I) and regular washer (H). Snug tight with an included wrench (J).
Step 6. Tighten All Screws Tool required: Allen key (K) Tighten all screws on the top, cylinder, adjustment lever, and base until snug. Flip the desk onto its wheels

Use Instructions

Roll desk into desired position.
Lock casters to prevent the table from rolling.
To lift, pull up on the adjustment lever.
To lower, pull up on the adjustment lever while pressing down on the table top.
Release adjustment lever to lock-in table height.

FAQs

Q. Can I use it without the wheels?
A. No. The base is not flat and will wobble without wheels.
Q. How high and how low can my desk go?
A. Maximum height is 41.9 inches. Minimum height is 27.1 inches.
Q. Why won’t my desk adjust its height?
A. The adjustment wire is likely not clipped into the adjustment lever correctly. Reference the diagram in Step 2 for an example of the correct installation.

Safety
Do not tip the desk over or place it upside down. Do not place more than 35 lbs. on the desktop.
Customer Service Information
Telephone: 800-323-5565
Fax: 310-533-3899
Hours: 8:30 AM – 4:30 PM (PST)