YONGFANG T50 True Wireless Earbuds User Manual
- June 8, 2024
- YONGFANG
Table of Contents
T50 True Wireless Earbuds
User Manual
T50 True Wireless Earbuds
T50 User Manual
Easy Pairing
- Put the headset into the charging case, the headset automatically turns off and starts charging with the red light on.
- At the same time remove the headset from the charging case. The red and white light flashes rapidly, and after the left and right ear are successfully connected, one of the headphones alternately flashes red and white, and the other headphone flashes white slowly.
- Open the phone Bluetooth search pairing name “T50”, click it that is connected to the headset.
- After use, please put it back into the charging case, the headset is disconnected from the phone and into the charging state.
- When using, just take it out of the charging case, it will be automatically paired to use.
Operation Guide
- Power on: Press and hold for 2 seconds.
- Power off: long press for 5 seconds.
- Auto Power Off: 5 minutes without connection or battery power below 3.1V, auto power off, red light blinks 3 times and then goes off.
- Play/Pause: Click.
- Answer/hang up the phone: click.
- Reject incoming call:When incoming call, long press for 3 seconds.
- Previous song:Three clicks on the left ear.
- Next song:Triple-click right ear. 9.
- Volume down:double-click the left ear
- Volume plus:double tap right ear
- Activate voice assistant: long press for 3 seconds to turn on/off
- Clear the connection record: connect to the phone after the left ear or right ear 6 clicks
Charging
Earbuds
When charging: earbuds always light up red light, charging box white light
flashing.
Headphones fully charged: headphones red light off, charging compartment white
light off
Charging time:1 hour
Low battery: headphones red light blinking
Packing Detail
Earphone
User’s Uanual
Charging Cable
User Manual
Gift Box & Paper Trays
Product Specifications
Wireless Version: V5.3
Driver Size: 6mm
Impedance: 16
Sensitivity: 100 +/- 3dB
Frequency Response: 20Hz~20kHz
Working Distance: Up to 10M
Battery Capacity: 3.7V/45mAh
Playing Time: Up to 6 hours
Charging Port: USB Type C
Charging Time: 1.5hours
Standy Time: Up to 30days
FAQ
- The headset should be stored in a dry and ventilated environment. Prevent the performance of the product affected by oil, moisture and dust.
- Avoid using stimulants, organic solvents or containing these ingredients to clean the headset.
- The use of the headset must be correct in accordance with the instructions, pay attention to the impact of the use of the environment on the headset. To ensure a smooth connection, it is recommended that the The distance between the headset and the phone is 10 meters.
- If the headset is not connected or poorly connected, please do not disassemble the headset or accessories by yourself.
- Charging box charging, please use a standard charger or charger to meet the requirements.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>