REX NORDIC AH-800 Rexener Bioheater Service Kit Instruction Manual
- June 8, 2024
- REX NORDIC
Table of Contents
REX NORDIC AH-800 Rexener Bioheater Service Kit
REX NORDIC SERVICE
We are the service agent for Airrex and Rexener products. Trained by the manufacturer, our service personnel maintain your devices professionally. We use well-equipped service vans which are easy to order on-site, wherever you need.
WHY OUR SERVICE?
- We are the importer of and official service shop for Aired and Rexene products.
- We only use original spare parts.
- All spare parts for devices are available in our warehouse.
- A well-trained, professional and friendly maintenance staff.
- We provide quick and reliable maintenance service.
- Our service comes to your machine – it is that easy!
REPLACING THE FILTER, NOZZLE AND THE GASKET KIT
REXENER BIOHEATER WATER HEATER
NOTE! Check if you have a filter in your tank. If not, please contact Rex
Nordic’s service.
We’ll send you a new tank free of charge.
Before starting, unplug the power cord.
If your heater has a damper in front of the burner, remove it before you start servicing.
Disconnect the power cables of the burner.
Remove the fuel filter and replace it with a new one.
Remove the burner’s fastening nuts on both sides (2 pcs) and remove the burner.
Open the nozzle damper screws (4 pcs).
Lift the damper out to access the igniter screw and air flow regulator screw.
First remove the air flow regulator screw and loosen the igniter out of the nozzle frame.
Then remove the air flow regulator carefully by lifting it up to reveal the nozzle.
Remove the nozzle with a 16 mm and 19 mm spanner.
Check the nozzle chamber for impurities and clean it before installing the new nozzle.
Finger-tighten the new nozzle into place, and finish by tightening it firmly with spanners.
After this, clean the air flow regulator and damper and install them into
place.
First place the air flow regulator on the nozzle frame. Then tighten the
igniter screw, adjust the air flow regulator to the correct position in the
centre of the igniter and tighten the screw.
Put the damper in its place and make sure that the guiding groove is in the correct position. Tighten the screws. The burner is now ready to be connected to the heater.
Remove the gasket from the heating pipe and install the new one.
- Install the burner and tighten the screws. Before tightening, check the position of the burner to ensure that it is in the centre of the heating pipe by confirming that the fastening nuts are symmet-rically in the appropriate grooves.
- Install the fuel hose and power cables.
- Connect the power cable to the power socket and press the power switch to activate the heater.
- Remember to bleed the burner to discharge any air from the system. (Bleeding instructions can be found in the manual.)
- Test run the device for at least 10 min and ensure that everything is in order. The heater is ready for use.
SOOTY AIR NOZZLE?
If the air nozzle is extremely sooty, the air nozzle must also be replaced!
SERVICE & TECHNICAL SUPPORT
013 553 773 70
service@rexnordic.com
Service is open on weekdays from 7 am to 3 pm.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>