HAVIT HV3638C-BLK 6W 240V Up and Down LED Wall Light Instruction Manual
- June 4, 2024
- havit
Table of Contents
Instruction Manual
HV3638C-BLK 6W 240V Up and Down LED Wall Light
Mini Block & Block Wall Light Installation Instructions
Product Specifications
Model No.| HV3638C-BLK| HV3638W-BLK| HV3638C-WHT| HV3638W-WHT| HV3639T-BLK|
HV3639T-WHT
Name| Mini Block| Block
Material| Aluminum| Aluminum
Colour| Black| White| Black| White| Black| White
IP Rating| IP54| IP54
Protection Class| 1 (240v Requires Earth)| 1 (240v Requires Earth)
Input Voltage| 240v AC| 240v AC
Lamp Base| Built-in LED| Built-in LED
Lamp Wattage| 2x 3w| 2x 4.5w
Colour Temp| 5500k| 3000k| 5500k| 3000k| TRI Colour – 3000k, 4000k, 5500k
Lumens| 2x 210lm| 2x 200lm| 2x 210lm| 2x 200lm| 2x 300lm, 2x 310lm, x 320lm
CRI| > 80| > 80
Wiring| Parallel| Parallel
Dimmable| No| No
Warranty| 3 Years Replacement| 3 Years Replacement
Important Safety Issues:
• This product must be installed by a qualified electrician according to
AS/NZS 3000.
• Ensure all electrical mains are disconnected before any installation.
• Modification of this product will void any warranty.
• Havit Lighting does not take responsibility for wrong installation,
incorrect use, or use of installation material that does not belong to the
system.
• Aluminium and 304SS fittings must not be installed within 5km of any
saltwater environments.
• All o-rings and seals must be in place correctly to maintain the warranty
• This form may be updated at any time due to product improvements, please
check the online installation form for the most current version.
Steps for Installation:
1. Make sure that the electrical circuit is free of voltage (master switch
off )
2. Remove screws from the top and bottom of the fitting and set them aside.
3. Remove base plate from fitting.
4. Install the base plate to the wall in the desired location using
appropriate screws for application.
5. Seal all holes including cable entry and around screws
6. Connect the cable – use wire with earth; connect the earth first, then
live and a neutral wire.
7. For HV3639 Models, fitting is preset to 3000k, to change the slide switch
located inside the base of fitting to desired color temperature.
8. Reattach fitting to base plate making sure screws are tight to avoid any
water penetration.
9. Apply silicon around the edge of the fitting to prevent any water from
getting inside to electrical connections.
10. All connections must be carried out carefully, inspect all contacts
before switching back on the electric circuit.
Must be installed by a licensed electrician
Contact Details:
143 Beauchamp Road| Tel: 02 9381 8300
Matraville NSW 2036| Fax: 02 9666 8881
Australia| Email: sales@havit.com.au
| Web: www.havit.com.au
**Warranty Terms & Conditions*| Additional Information**
---|---
|
https://havit.com.au/pages/warranty-terms-and-conditions|
https://havit.com.au/
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>