aero-spa 102232 Bacteria Test Kit Instruction Manual
- June 9, 2024
- aero-spa
Table of Contents
aero-spa 102232 Bacteria Test Kit
The Watersafe® Rapid Bacteria Test for pools and spas in an antibody-based test kit for detecting the presence of bacteria in water, including E. Coli, Pseudomonas aeruginosa, species of Shigella, Enterobacter, and many other coliform and non-coliform bacteria.
Before you begin
- Each foil packet contains:
- Test Strip
- Test Vial
- Disposable Pipette
- Desiccant (to be discarded)
- Do not open foil pouch until immediately prior to use
- Use the sample viral provided to run the test
- Do not re-use any test strips, pipettes, or vials
- Store test at 50-86°F (10-30°C)
This kit contains information and materials, which are derived in whole or in part from information and materials supplied to Aero-Spa LLC, and are protected by their respective copyright. WaterSafe is a trademark of Silver Lake Research Corporation.
- Open foil pouch and take out all contents.
- Using a clean pipette, place exactly ONE pipette-full of water into the test vial. To draw up sample, tightly squeeze the bulb at the end of the pipette and place the open end into water sample. Release the bulb to pick up sample, then squeeze again to expel sample into vial.
- Gently swirl vial. Let stand five (5) minutes. Swirl vial again and return vial to flat surface.
- Place test strip into sample vial with arrows pointing down
- Wait 10 minutes. Do not disturb the strip or vial during this time. Reddish lines will appear on strips.
Take strip out of the vial and read results: Please note that Watersafe® is a screening test and cannot be used to certify water as safe or unsafe. Watersafe® provides approximate results ONLY when used in strict accordance with instructions. Silver Lake Research Company & Aero-Spa, LLC expressly disclaim any liability resulting from use of this product, failure to follow instructions, or reliance on test results
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>