UGREEN CD345 Magnetic Wireless Car Charger User Manual

UGREEN CD345 Magnetic Wireless Car Charger

Product Overview

1. Wireless Charging Area
2. Power Port
3. Ball Joint
4. Adjustable Arm
5. Pivot
6. Locking Lever
7. Suction Cup
8. Pull-ring
9. Dashboard Pad Mounting Disk

Before Setup

1. Put the suction base on a flat location before peeling off any films (not suitable for curved surfaces).
2. Press the base and pivot the arm to ensure the adjustment range of the arm meets your need.

Dashboard

STEP 1
Clean the desired location and peel off the protective film to stick the pad. Press the pad to ensure a firm adhesive grip, then wait for 15 minutes.
Note: Make sure the pull-ring faces the windshield.

STEP 2
Insert the joint into the groove and tighten the nut.

STEP 3
Tear off the film and stick the mount onto the pad.

STEP 4
Apply pressure to ensure a firm grip before pressing down the locking lever. Then wait for 4 hours before use.

STEP 5
Snap to charge.

Remove The Mount

1. Pull up the locking lever.
2. Pull the tab up until the base gets off the dashboard pad.
3. Remove the pad via the pull ring. If any rough residue is left, you can use adhesive remover to get rid of it.

Product Overview

1. Wireless Charging Area
2. Power Port
3. Ball Joint
4. Twist Lock
5. Supporting Ring
6. Air Vent Hook Clip

Air Vent

STEP 1
Insert the joint into the groove and tighten the nut.

STEP 2
Release the hook.

STEP 3
Insert the hook into the air vent and adjust or remove the supporting ring due to the different circumstances

STEP 4
Rotate the twist lock to let the hook vise the air vent blades. Do not apply excessive pressure to avoid damaging the blades.

STEP 5
Snap to charge.

Specifications

Package Contents

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to two conditions This device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
FCC NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.

EU Declaration of Conformity

Hereby, Ugreen Group Limited declares that the product is in compliance with Directive 2014/53/EU & 2011/65/EU. Learn more about the EU Declaration of Conformity is available at the following internet address: https://www.ugreen.com/download/ Ugreen Group Limited Add: Ugreen Building, Longcheng Industrial Park, Longguanxi Road, Longhua, Shenzhen, ChinaEU REP: Ugreen Group GmbH Add: Mannheimer Str. 13, 30880 Laatzen, Germany

Declaration of Conformity

Hereby, Ugreen Group Limited declares that the product is in compliance with Directive UK Radio Equipment Regulations(SI 2017 No.1206)& The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012 (SI 2012 No.3032). Learn more about the GB Declaration of Conformity is available at the following internet address: https://www.ugreen.com/download/

Ugreen Group Limited
Add: Ugreen Building, Longcheng Industrial Park, Longguanxi Road, Longhua, Shenzhen, China
UK REP: Acumen Intemational Business Consultancy Limited
Add: 94 Ock Street, Abingdon, OX14 5DH, UK

Important WEEE Information

This symbol on the product(s) and/or accompanying documents indicates that under the new Directive 2012/19/EU on waste electrical and electronic equipment (WEEE), product(s) used electrical and electronic equipment (WEEE) should not be mixed with general household waste. For proper treatment, recovery, and recycling, please take this product(s) to designated collection points where it will be accepted free of charge. Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on human health and the environment, which could otherwise arise from inappropriate waste handling.

• Please contact your local authority for further details of your nearest designated collection point.
• Penalties may be applicable for incorrect disposal of this waste, in accordance with your national legislation.
• For professional users in the European Union
• If you wish to discard electrical and electronic equipment (EEE), please contact your dealer or supplier for further information.
• For disposal in countries outside of the European Union
• This symbol is only valid in the European Union (EU). If you wish to discard this product please contact your local authorities or dealer and ask for the correct method of disposal.

IC Statement
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

1. this device may not cause interference;
2.  this device must accept any interference, including interference that may cause undesired operation.

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Warranty Information

A limited 2-year warranty applies to all UGREEN products purchased from UGREEN official stores or authorized sellers. Please feel free to contact us if you run into any problems.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>